Product Categories See All
Track Order Status
SDS Sheet 0075910Printer Friendly View
Safety Data Sheet | | Date of Issue: |Revision Date: 8/14/2015 |Revision Number: Imperial Supplies Part Number: 0075910 SECTION 1: IDENTIFICATION 1.1. Product Identifier Product Form: Product Name: DynatexÂ® 49411 Muffler and Tailpipe Sealant CAS No: Synonyms: 49411CL12 1.2. Intended Use of the Product Use of the substance/mixture: Refer to Technical Data 1.3. Name, Address, and Telephone of the Responsible Party Company Dynatex a division of Soudal Accumetric 350 Ring Road Elizabethtown, KY, 42701 USA Phone: (270) 769-3385 1.4. Emergency Telephone Number Emergency |(800) 424-9300 CHEMTREC number | SECTION 2: HAZARDS IDENTIFICATION 2.1. Classification of the Substance or Mixture Classification (GHS-US) EYE |Category 1 DAMAGE/IRRITAT| ION | SKIN |Category 2 CORROSION/IRRI| TATION | | 2.2. Label Elements GHS-US Labeling Hazard Pictograms (GHS-US) |Corrosio| | | | | |n | | | | | Signal Word (GHS-US) |Danger Hazard Statements (GHS-US) |Causes serious eye damage |Causes skin irritation Precautionary Statements |Response: (GHS-US) |If in eyes: Rinse cautiously with water for several |minutes. Remove contact lenses, if present and easy |to do. Continue rinsing. |If on skin: Wash with plenty of soap and water. |If skin irritation occurs: Get medical |advice/attention. |Read label before use. |Take off contaminated clothing and wash it before |reuse. |Prevention: |Wash hands thoroughly after handling. |Wear eye protection/face protection. |Wear protective gloves. |Storage: |N/A. |Disposal: |N/A. 2.3. Other Hazards Other Hazards Not Contributing to the Classification: None known. 2.4. Unknown Acute Toxicity (GHS-US) 0%. SECTION 3: COMPOSITION/INFORMATION ON INGREDIENTS 3.1. Substance Name |Product identifier |% |Classification | | |(GHS-US) | | | | | | | | | | | | | | | Full text of H-phrases: See Section 16 3.2. Mixture Name |Product identifier |% |Classification | | |(GHS-US) Sodium silicate |1344-09-8 |15% - | | |35% | Water |7732-18-5 |20% - | | |40% | | | | | | | | | | SECTION 4: FIRST AID MEASURES 4.1. Description of First Aid Measures First-aid Measures General: First-aid Measures After Inhalation: Remove to fresh air. If symptoms persist, obtain appropriate medical attention. First-aid Measures After Skin Contact: Thoroughly wash exposed skin with soap and water. First-aid Measures After Eye Contact: Flush eyes with plenty of water for at least 15 minutes, occasionally lifting upper and lower eyelids. Check for and remove any contact lens. Do not use an eye ointment without seeking medical attention. First-aid Measures After Ingestion: Do not induce vomiting. Immediately drink two glasses of water. Never give anything to an unconscious person. Get medical attention. 4.2. Most important symptoms and effects, both acute and delayed Symptoms/Injuries: Symptoms/Injuries After Inhalation: Symptoms/Injuries After Skin Contact: Symptoms/Injuries After Eye Contact: Symptoms/Injuries After Ingestion: Chronic Symptoms: 4.3. Indication of Any Immediate Medical Attention and Special Treatment Needed Comments: Treat according to person's condition and specifics of exposure. SECTION 5: FIRE-FIGHTING MEASURES 5.1. Extinguishing Media Suitable Extinguishing Media: Carbon Dioxide, Dry Chemical, Foam. Use water fog to cool material in vicinity of fire. Unsuitable Extinguishing Media: N/A. 5.2. Special Hazards Arising From the Substance or Mixture Fire Hazard: None known. Explosion Hazard: None known. Reactivity: 5.3. Advice for Firefighters Precautionary Measures Fire: Firefighting Instructions: Breathing apparatus required when fighting fires in enclosed spaces. Protection During Firefighting: SECTION 6: ACCIDENTAL RELEASE MEASURES 6.1. Personal Precautions, Protective Equipment and Emergency Procedures General Measures: 6.1.1. For Non-emergency Personnel Protective Equipment: Emergency Procedures: 6.1.2. For Emergency Responders Protective Equipment: Emergency Procedures: 6.2. Environmental Precautions 6.3. Methods and Material for Containment and Cleaning Up For Containment: Methods for Cleaning Up: Observe all personal protection equipment recommendations. Soak up with inert absorbent. Store in a partly filled, closed container until disposal. Prevent product from entering drains. Local, state and federal regulations may apply to releases and disposal of this material, as well as those materials and items employed in cleanup of releases. 6.4. Reference to Other Sections See heading 8, Exposure Controls and Personal Protection. SECTION 7: HANDLING AND STORAGE 7.1. Precautions for Safe Handling Additional Hazards When Processed: Avoid eye contact and repeated prolonged contact with the skin. Keep out of reach from children. Hygiene Measures: 7.2. Conditions for Safe Storage, Including Any Incompatibilities Technical Measures: Storage Conditions: Store in a cool dry place. Protect from freezing and excessive heat. Store away from caustics and oxidizers. 7.3. Specific End Use(s) SECTION 8: EXPOSURE CONTROLS/PERSONAL PROTECTION 8.1. Control Parameters Occupational Exposure Limits: Ingredient Name ACGIH TLV OSHA PEL STEL Sodium silicate N/A N/A N/A Water 0 N/A N/A 8.2. Exposure Controls Appropriate Engineering | Controls | Personal Protective Equipment|N/A. |Ventilation: Good general ventilation should be |sufficient. |Ingestion: Do not eat, drink or smoke during work. Materials for Protective | Clothing | Hand Protection | Eye Protection |Safety goggles or glasses with side shields are |recommended. Skin and Body Protection |Impervious gloves are suggested. Respiratory Protection |If engineering controls do not maintain airborne |concentrations of hazardous ingredients below TLV, |then a NIOSH/MSHA approved organic vapor respirator |should be used. Not required under normal usage and |adequate ventilation. Thermal Hazard Protection | SECTION 9: PHYSICAL AND CHEMICAL PROPERTIES 9.1. Information on Basic Physical and Chemical Properties Physical State |Paste Appearance | Odor |Slight Odor Threshold |N/A pH |12 Relative Evaporation Rate (butyl |Slower than n-butyl acetate acetate=1) | Melting Point |0C Freezing Point | Boiling Point |100C Flash Point |Not determined Auto-ignition Temperature |N/A Decomposition Temperature |N/A Flammability (solid, gas) |N/A Vapor Pressure |Not determined Relative Vapor Density at 20 Â°C |Lighter than air Relative Density | Specific Gravity |1.9 Solubility |Dilutable in wet stage Partition coefficient: |N/A n-octanol/water | Viscosity |750,000 cPs Lower Flammable Limit |N/A Upper Flammable Limit |N/A 9.2. Other Information VOC%: 0 grams/liter SECTION 10: STABILITY AND REACTIVITY 10.1 Reactivity 10.2 Chemical Stability Stable. 10.3 Possibility of Hazardous Reactions Hazardous polymerization: Will not occur. 10.4 Conditions to Avoid Excessive heat and freezing. 10.5 Incompatible Materials Reacts with acids, ammonium salts, reactive metals, and some organics. 10.6 Hazardous Decomposition Products Thermal breakdown of this product during fire or very high heat conditions may evolve the following hazardous decomposition products: None known. SECTION 11: TOXICOLOGICAL INFORMATION 11.1. Information on Toxicological Effects Acute Toxicity: Special Hazard Information on Components: No known applicable information. Component Toxicology Information: No known applicable information. Skin Corrosion/Irritation: Serious Eye Damage/Irritation: Respiratory or Skin Sensitization: Germ Cell Mutagenicity: Carcinogenicity: Reproductive Toxicity: Specific Target Organ Toxicity (Single Exposure): Specific Target Organ Toxicity (Repeated Exposure): Aspiration Hazard: Symptoms/Injuries After Inhalation: Symptoms/Injuries After Skin Contact: Symptoms/Injuries After Eye Contact: Symptoms/Injuries After Ingestion: Chronic Symptoms: SECTION 12: ECOLOGICAL INFORMATION 12.1. Toxicity 12.2. Persistence and Degradability 12.3. Bioaccumulative Potential 12.4. Mobility in Soil 12.5. Other Adverse Effects Environmental Fate and Distribution: Complete information is not yet available. Environmental Effects: High pH is harmful to aquatic life. Fate and Effects in Waste Water Treatment Plants: Complete information is not yet available. SECTION 13: DISPOSAL CONSIDERATIONS 13.1. Waste treatment methods Waste Disposal Recommendations: We make no guarantee or warranty of any kind that the use or disposal of this product complies with all local, state, or federal laws. It is also the obligation of each user of the product mentioned herein to determine and comply with the requirements of all applicable statutes. This product is not known to be regulated under RCRA regulations. Disposal of unused portions of this product and process waste containing this product should be done only after a careful evaluation and in compliance with all federal, local and state laws. Additional Information: SECTION 14: TRANSPORT INFORMATION 14.1 In Accordance with DOT Proper Shipping Name |N/A Hazard Class |N/A |<PICTOGRAM PHRASE> Identification Number|N/A | Label Codes | | ERG Number | 14.2 In Accordance with IMDG Proper Shipping Name |Not subject to IMDG code. Hazard Class | Identification Number| Label Codes | |<PICTOGRAM PHRASE> ntification Of The | | Substance/m | | EmS-No. (Fire) | | EmS-No. (Spillage) | | 14.3 In Accordance with IATA Proper Shipping Name |Not subject to IATA regulations. Identification Number| |<PICTOGRAM PHRASE> Hazard Class | | Label Codes | | ntification Of The | | Substance/m | | ERG Code (IATA) | SECTION 15: REGULATORY INFORMATION 15.1 US Federal Regulations <COMPONENT> The contents of this MSDS comply with the OSHA Hazard Communication Standard 29 CFR 1910.1200. SARA Title III Section 302 Extremely Hazardous Substances: None. SARA Titre III Section 304 CERCLA Substances dangereuses: None. SARA Title III Section 313 Toxic Chemicals: None present or none present in regulated quantities. SARA Section 311/312 Hazard Classes |No components subject to 40 CFR 370. Toxic Substances Control Act (TSCA) |All chemical substances found in this product |comply with the Toxic Substances Control Act |inventory reporting requirements. 15.2 US State Regulations <COMPONENT> California Proposition 65: This product contains the following chemical(s) listed by the State of California under the Safe Drinking Water and Toxic Enforcement Act of 1986 (Proposition 65) as being known to cause cancer, birth defects or other reproductive harm: None known. SECTION 16: OTHER INFORMATION, INCLUDING DATE OF PREPARATION OR LAST REVISION Revision date |8/14/2015 Other |This document has been prepared in accordance with the SDS Information |requirements of the OSHA Hazard Communication Standard 29 CFR |1910.1200. GHS Full Text Phrases: ----| | -- | | ----| | -- | | ----| | -- | | ----| | -- | | ----| | -- | | Grainger disclaimer.
The information contained in this SDS was obtained from current and reliable sources, however, the data is provided without any warrenty, expressed or implied, regarding its correctness or accuracy. Since the conditions or handling, storage and disposal of this product are beyond the control of Imperial Supplies LLC, Imperial will not be responsible for loss, injury, or expense arising out of the products improper use. No warranty, expressed or inferred, regarding the product described in this 'SDS' shall be created or inferred by any statement in this 'SDS'. Various government agencies may have specific regulations regarding the transportation, handling, storage, use, or disposal of this product which may not be covered by this 'SDS'. The user is responsible for full compliance.