Product Categories See All
Track Order Status
SDS Sheet 0065820Printer Friendly View
Safety Data Sheet Date of Issue: |Revision Date: 23-Jun-2015 |Revision Number: 1 Imperial Supplies Part Number: 0065820 SECTION 1: IDENTIFICATION 1.1. Product Identifier Product Form: Product Name: ULTRA-SLICK ENGINE ASSEMBLY LUBE 40Z CAS No: Synonyms: None 1.2. Intended Use of the Product Use of the substance/mixture: Lubricant 1.3. Name, Address, and Telephone of the Responsible Party Company ITW Permatex 10 Columbus Blvd. Hartford, CT 06106 USA Phone: 1-87-Permatex (877) 376-2839 1.4. Emergency Telephone Number Emergency |Chem-Tel: 800-255-3924, International Emergency: 00+1+ number |813-248-0585, Contract Number: MIS0003453 SECTION 2: HAZARDS IDENTIFICATION 2.1. Classification of the Substance or Mixture Classification (GHS-US) Ex. Compressed|H280 gas | | | 2.2. Label Elements GHS-US Labeling Hazard Pictograms (GHS-US) | | | | | | Signal Word (GHS-US) | Hazard Statements (GHS-US) | Precautionary Statements | (GHS-US) | 2.3. Other Hazards Other Hazards Not Contributing to the Classification: Not applicable. The classification as a carcinogen need not apply if it can be shown that the substance contains less than 3 % DMSO extract as measured by IP 346. This note applies only to certain complex oil derived substances in Annex I. 2.4. Unknown Acute Toxicity (GHS-US) 14.75 % of the mixture consists of ingredient(s) of unknown toxicity. SECTION 3: COMPOSITION/INFORMATION ON INGREDIENTS 3.1. Substance Name |Product identifier |% |Classification | | |(GHS-US) | | | | | | | | | | | | | | | Full text of H-phrases: See Section 16 3.2. Mixture Name |Product identifier |% |Classification | | |(GHS-US) RESIDUAL OILS (PETROLEUM), |64742-62-7 |60-100 | SOLVENT-DEWAXED | |Trade | | |Secret *| | | | | | | | | | | | | *The exact percentage (concentration) of composition has been withheld as a trade secret. SECTION 4: FIRST AID MEASURES 4.1. Description of First Aid Measures First-aid Measures General: Get medical advice/attention if you feel unwell. Self-protection of the first aider: Use personal protective equipment as required. Avoid contact with skin, eyes or clothing. First-aid Measures After Inhalation: IF INHALED: Remove victim to fresh air and keep at rest in a position comfortable for breathing. If symptoms persist, call a physician. First-aid Measures After Skin Contact: IF ON SKIN:. Wash skin with soap and water. If skin irritation persists, call a physician. Wash contaminated clothing before reuse. First-aid Measures After Eye Contact: IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists: Get medical advice/attention. First-aid Measures After Ingestion: IF SWALLOWED:. Do NOT induce vomiting. Never give anything by mouth to an unconscious person. Call a physician. 4.2. Most important symptoms and effects, both acute and delayed Symptoms/Injuries: See section 2 for more information. Symptoms/Injuries After Inhalation: Symptoms/Injuries After Skin Contact: Symptoms/Injuries After Eye Contact: Symptoms/Injuries After Ingestion: Chronic Symptoms: 4.3. Indication of Any Immediate Medical Attention and Special Treatment Needed Note to physicians: Treat symptomatically. SECTION 5: FIRE-FIGHTING MEASURES 5.1. Extinguishing Media Suitable Extinguishing Media: Carbon dioxide (CO2), Dry chemical, Foam. Unsuitable Extinguishing Media: None. 5.2. Special Hazards Arising From the Substance or Mixture Fire Hazard: None in particular. Explosion Hazard: Sensitivity to Mechanical Impact: None. Sensitivity to Static Discharge: None. Reactivity: 5.3. Advice for Firefighters Precautionary Measures Fire: Firefighting Instructions: Protection During Firefighting: As in any fire, wear self-contained breathing apparatus pressure-demand, MSHA/NIOSH (approved or equivalent) and full protective gear. SECTION 6: ACCIDENTAL RELEASE MEASURES 6.1. Personal Precautions, Protective Equipment and Emergency Procedures General Measures: Avoid contact with eyes and skin. 6.1.1. For Non-emergency Personnel Protective Equipment: Emergency Procedures: 6.1.2. For Emergency Responders Protective Equipment: Emergency Procedures: 6.2. Environmental Precautions Do not flush into surface water or sanitary sewer system. See Section 12 for additional ecological Information. 6.3. Methods and Material for Containment and Cleaning Up For Containment: Prevent further leakage or spillage if safe to do so. Methods for Cleaning Up: Ensure adequate ventilation. Soak up with inert absorbent material. Sweep up and shovel into suitable containers for disposal. Prevention of secondary hazards: Clean contaminated objects and areas thoroughly observing environmental regulations. 6.4. Reference to Other Sections See heading 8, Exposure Controls and Personal Protection. SECTION 7: HANDLING AND STORAGE 7.1. Precautions for Safe Handling Additional Hazards When Processed: Handle in accordance with good industrial hygiene and safety practice. Hygiene Measures: Handle in accordance with good industrial hygiene and safety practice. Regular cleaning of equipment, work area and clothing is recommended. 7.2. Conditions for Safe Storage, Including Any Incompatibilities Technical Measures: Storage Conditions: Keep containers tightly closed in a dry, cool and well-ventilated place. Incompatible materials: Strong oxidizing agents. 7.3. Specific End Use(s) SECTION 8: EXPOSURE CONTROLS/PERSONAL PROTECTION 8.1. Control Parameters 8.2. Exposure Controls Appropriate Engineering |Eyewash station. Controls | Personal Protective Equipment| Materials for Protective | Clothing | Hand Protection | Eye Protection |Wear safety glasses with side shields (or goggles). Skin and Body Protection |Wear protective gloves and protective clothing. Respiratory Protection |None under normal use conditions. Thermal Hazard Protection | SECTION 9: PHYSICAL AND CHEMICAL PROPERTIES 9.1. Information on Basic Physical and Chemical Properties Physical State |Liquid Appearance |Red Odor |Petroleum odor Odor Threshold |No information available pH |No information available Relative Evaporation Rate |No information available (butylacetate=1) | Melting Point |No information available Freezing Point |No information available Boiling Point |No information available Flash Point |288 Â°C / 550 Â°F Cleveland Open Cup Auto-ignition Temperature |No information available Decomposition Temperature |No information available Flammability (solid, gas) |No information available Vapor Pressure |No information available Relative Vapor Density at 20 Â°C |No information available Relative Density |0.92 Specific Gravity | Solubility |Negligible Partition coefficient: |No information available n-octanol/water | Viscosity |No information available Lower Flammable Limit |No information available Upper Flammable Limit |No information available 9.2. Other Information Softening point: No information available. Molecular weight: No information available. VOC Content (%): 0 Density: No information available. Bulk density: No information available. SECTION 10: STABILITY AND REACTIVITY 10.1 Reactivity No data available. 10.2 Chemical Stability Stable under recommended storage conditions. 10.3 Possibility of Hazardous Reactions None under normal processing. 10.4 Conditions to Avoid Excessive heat. 10.5 Incompatible Materials Strong oxidizing agents. 10.6 Hazardous Decomposition Products Carbon oxides, Oxides of sulfur. SECTION 11: TOXICOLOGICAL INFORMATION 11.1. Information on Toxicological Effects Acute Toxicity: The following values are calculated based on chapter 3.1 of the GHS document . ATEmix (oral) 5020 mg/kg ATEmix (dermal) 2008 mg/kg Skin Corrosion/Irritation: Serious Eye Damage/Irritation: Respiratory or Skin Sensitization: No information available. Germ Cell Mutagenicity: No information available. Carcinogenicity: Reproductive Toxicity: Specific Target Organ Toxicity (Single Exposure): Specific Target Organ Toxicity (Repeated Exposure): Aspiration Hazard: Symptoms/Injuries After Inhalation: May cause irritation of respiratory tract. Symptoms/Injuries After Skin Contact: May cause skin irritation and/or dermatitis. Symptoms/Injuries After Eye Contact: Contact with eyes may cause irritation. May cause redness and tearing of the eyes. Symptoms/Injuries After Ingestion: Ingestion may cause irritation to mucous membranes. Chronic Symptoms: No information available. SECTION 12: ECOLOGICAL INFORMATION 12.1. Toxicity Ecotoxicity: 15 % of the mixture consists of components(s) of unknown hazards to the aquatic environment. 12.2. Persistence and Degradability No information available. 12.3. Bioaccumulative Potential No information available. 12.4. Mobility in Soil No information available. 12.5. Other Adverse Effects No information available. SECTION 13: DISPOSAL CONSIDERATIONS 13.1. Waste treatment methods Waste Disposal Recommendations: Disposal should be in accordance with applicable regional, national and local laws and regulations. Additional Information: Contaminated packaging: Do not reuse container. US EPA Waste Number: Not applicable. SECTION 14: TRANSPORT INFORMATION 14.1 In Accordance with DOT Proper Shipping Name |Not regulated Hazard Class | |<PICTOGRAM PHRASE> Identification Number| | Label Codes | | ERG Number | 14.2 In Accordance with IMDG Proper Shipping Name |Not regulated Hazard Class | Identification Number| Label Codes | |<PICTOGRAM PHRASE> ntification Of The | | Substance/m | | EmS-No. (Fire) | | EmS-No. (Spillage) | | 14.3 In Accordance with IATA Proper Shipping Name |Not regulated Identification Number| |<PICTOGRAM PHRASE> Hazard Class | | Label Codes | | ntification Of The | | Substance/m | | ERG Code (IATA) | SECTION 15: REGULATORY INFORMATION 15.1 US Federal Regulations <COMPONENT> SARA 313: Section 313 of Title III of the Superfund Amendments and Reauthorization Act of 1986 (SARA). This product does not contain any chemicals which are subject to the reporting requirements of the Act and Title 40 of the Code of Federal Regulations, Part 37. CWA (Clean Water Act): This product does not contain any substances regulated as pollutants pursuant to the Clean Water Act (40 CFR 122.21 and 40 CFR 122.4. CERCLA: This material, as supplied, does not contain any substances regulated as hazardous substances under the Comprehensive Environmental Response Compensation and Liability Act (CERCLA) (40 CFR 302) or the Superfund Amendments and Reauthorization Act (SARA) (40 CFR 355). There may be specific reporting requirements at the local, regional, or state level pertaining to releases of this material. SARA Section 311/312 Hazard Classes |Acute health hazard |Yes |Chronic Health Hazard |No |Fire hazard |No |Sudden release of pressure hazard No |Reactive Hazard |No Toxic Substances Control Act (TSCA) |Complies 15.2 US State Regulations <COMPONENT> California Proposition 65: This product does not contain any Proposition 65 chemicals. U.S. State Right-to-Know Regulations: U.S. EPA Label Information: EPA Pesticide Registration Number: Not applicable. SECTION 16: OTHER INFORMATION, INCLUDING DATE OF PREPARATION OR LAST REVISION Revision date |23-Jun-2015 Other |This document has been prepared in accordance with the SDS Information |requirements of the OSHA Hazard Communication Standard 29 CFR |1910.1200. GHS Full Text Phrases: ----| | -- | | ----| | -- | | ----| | -- | | ----| | -- | | ----| | -- | | Grainger disclaimer.
The information contained in this SDS was obtained from current and reliable sources, however, the data is provided without any warrenty, expressed or implied, regarding its correctness or accuracy. Since the conditions or handling, storage and disposal of this product are beyond the control of Imperial Supplies LLC, Imperial will not be responsible for loss, injury, or expense arising out of the products improper use. No warranty, expressed or inferred, regarding the product described in this 'SDS' shall be created or inferred by any statement in this 'SDS'. Various government agencies may have specific regulations regarding the transportation, handling, storage, use, or disposal of this product which may not be covered by this 'SDS'. The user is responsible for full compliance.