1/2 HP Effluent Pump,No Switch Included
|Scanner Description||1/2 Hp Effluent Pump,No Switch|
These 110 to 120V effluent pumps are used to drain treated water containing small solids from septic tanks and out to a drain field. They are compatible with most standard U.S. residential electrical wall outlets and have a Type A (two prongs, ungrounded) or Type B (three prongs, grounded) power cord plug.
Effluent pumps are used to drain treated water containing small solids from septic tanks. They have high heads (the height a pump can lift water before there is no more flow) and high pressure, compared to sewage ejector pumps, to efficiently push treated water out to a drain field.
- Item Effluent Pump
- HP 1/2
- Rated Voltage 120VAC
- Phase - Pumps 1
- Amps 9.5
- Body Material Stainless Steel
- Impeller Material Acetal
- Shaft Seal Material - Pumps Stainless Steel
- Switch Actuation No Switch Included
- Switch Electrical Connection No Switch Included
- Flow Rate @ 80 Ft. of Head 21 gpm
- Flow Rate @ 100 Ft. of Head 23 gpm
- Flow Rate @ 150 Ft. of Head 10 gpm
- Max. Head 175 ft.
- Min. Sump Pit Dia. 4"
- Body Dia. 4"
- Overall Height 22-1/2"
- Cord Length 10 ft.
- Discharge 1-1/4" FNPT
- Max. Diameter Solids 1/16"
- Max. Liquid Temp. 86 Degrees F
- Duty Cycle Continuous
- Alarm Included No
- RPM 3450
|VMRS (ATA) CODES||053-006-009||1/2 HP Effluent|
All information contained herein is the property of Imperial Supplies LLC, and is published here for your use only. Any reproduction or distribution of this information without prior written consent from Imperial Supplies LLC is strictly prohibited.
Imperial Supplies LLC does not provide services and products outside the United States
For more product information by email, click here