Register Now    |    Login

National Distributor of Quality Maintenance Supplies Since 1958

1-800-558-2808

Track Order Status
Order No:
Zip Code:

MSDS Sheet 0076720

Printer Friendly View
        
                          MATERIAL SAFETY DATA SHEET 
       
          ****SECTION I. CHEMICAL PRODUCT AND COMPANY INFORMATION****

DISTRIBUTOR'S NAME:       IMPERIAL SUPPLIES LLC
DISTRIBUTOR'S ADDRESS:    789 PACKER DRIVE
CITY, STATE, ZIP:         GREEN BAY, WI. 54304
INFORMATION NUMBER:       800-558-2808
EMERGENCY NUMBER:         800-255-3924 (CHEM-TEL)

PART NUMBER:     7672
PRODUCT NAME:    LUBRIPLATE SPRAY LUBE "A"      
FORMULA:         GREASE, SOLVENT AND PROPELLANT        



        ****SECTION II. HAZARDOUS INGREDIENTS/IDENTITY INFORMATION****

HAZARDOUS COMPONENTS    OSHA PEL     ACGIH TLV    OTHER LIMITS  %(OPTIONAL)
----------------------------------------------------------------------------
OIL MIST IN AIR         5MG/M3       5MG/M3                       
HEPTANE (142-82-5)      1600 MG/M3   1600 MG/M3                 38
PROPANE (74-98-6)       1000 PPM     1000 PPM                   20

*ACGIH - LISTED AS SIMPLE ASPHYXIANT (SEE SECTION III)


HMIS
HEALTH:        1 
FLAMMABILITY:  4
REACTIVITY:    0

WHMIS:  NOT A CONTROLLED PRODUCT UNDER (WHMIS) - CANADA

SPECIAL INSTRUCTIONS:  SEE SECTION 9


             ****SECTION III. HEALTH HAZARD DATA****

THRESHOLD LIMIT VALUE:    PEL: HEPTANE - 400 PPM, PROPANE - 1000 PPM, 
                          TLV FOR OIL MIST = 5MG/M3                   

EFFECTS OF OVEREXPOSURE:  INHALATION IS THE MOST LIKELY METHOD OF EXPOSURE. 
                          MINIMAL EFFECTS ARE EXPECTED AT LEVELS BELOW TLV OF
                          COMPONENTS. DIZZINESS, DROWSINESS, COUGHING, NASAL OR
                          THROAT IRRITATIONS AT HIGHER LEVESL. LPG MAY ACT AS A
                          SIMPLE ASPHYXIANT WITHOUT OTHER SIGNIFICANT  
                          PHYSIOLOGIC EFFECTS IF THE OXYGEN CONTENT IS LOW. IT
                          IS REPORTED THAT OVEREXPOSURE CAN CAUSE LIVER 
                          ABNORMALITIES, KIDNEY, LUNG AND SPLEEN DAMAGE IN TEST
                          ANIMALS.
                          
CARCINOGENICITY:  NTP? NO    IARC MONOGRAPHS? NO    OSHA REGULATED? NO



             ****SECTION IV. EMERGENCY AND FIRST AID PROCEDURES****

EYE CONTACT:     FLUSH WITH CLEAR WATER FOR 15 MINUTES OR UNTIL IRRITATION
                 SUBSIDES. IF IRRITATION PERSISTS, CONSULT A PHYSICIAN.

SKIN CONTACT:    REMOVE ANY CONTAMINATED CLOTHING AND WASH WITH SOAP AND WARM
                 WATER. 

INHALATION:      REMOVE TO FRESH AIR. IF BREATHING HAS STOPPED, ADMINISTER   
                 ARTIFICIAL RESPIRATION. GET MEDICAL HELP IMMEDIATELY.   

INGESTION:       IF INGESTED, CALL A PHYSICIAN IMMEDIATELY. DO NOT INDUCE 
                 VOMITING.


                 ****SECTION V. FIRE AND EXPLOSION HAZARD DATA****

FLASH POINT:         PROPELLANT: <O DEGREES F
FLAMMABLE LIMITS: 
LOWER LEVEL:         0.9% 
UPPER LEVEL:         9.5%

EXTINGUISHING MEDIA: FOAM, DRY CHEMICAL, CARBON DIOXIDE 

SPECIAL FIRE 
FIGHTING PROCEDURES: KEEP CONTAINERS COOL. USE AIR-SUPPLIED BREATHING EQUIPMENT
                     FOR CONFINED SPACES. USE SHIELDING TO PROTECT PERSONEL 
                     AGAINST BURSTING CONTAINERS.

UNUSUAL FIRE AND 
EXPLOSION HAZARDS:   DO NOT SPRAY NEAR OPEN FLAME. AT EVELATED TEMEPRATURES    
                     (OVER 130 DEGREES F), AEROSOL CONTAINERS MAY VENT, BURST, 
                     OR RUPTURE. 


            ****SECTION VI. PHYSICIAL/CHEMICAL CHARACTERISTICS****

BOILING POINT:            (AEROSOL) N/A
VAPOR PRESSURE (MM HG):   AEROSOL @ 130 DEGREES F - 115 PSIG
VAPOR DENSITY (AIR = 1):  >1
SOLUBILITY IN WATER:      INSOLUBLE 
APPEARANCE AND ODOR:      BEIGE MIST WITH ODOR OF SOLVENT FROM AEROSOL CAN
SPECIFIC GRAVITY: 
(H2O = 1)                 0.94 
MELTING POINT:            SPRAY
EVAPORATION RATE:         FASTER
(BUTYL ACETATE = 1)



              ****SECTION VII. REACTIVITY DATA****

STABILITY:                 STABLE
CONDITIONS
TO AVOID:                  AVOID SPRAYING INTO OPEN FLAME OR ONTO RED HOT 
                           SURFACE.
INCOMPATIBILITY: 
(MATERIALS TO AVOID)       STRONG OXIDIZERS 
HAZARDOUS DECOMPOSITION
OR BY PRODUCTS:            MAY FORM CARBON MONOXIDE IF COMBUSTION IS NOT 
                           COMPLETE.
CONDITIONS TO AVOID:       N/A
HAZARDOUS POLYMERIZATION:  WILL NOT OCCUR



              ****SECTION VIII. SPILL OR LEAK PROCEDURES****

STEPS TO BE TAKEN IN CASE MATERIL IS RELEASED OR SPILLED:
REMOVE SOURCES OF IGNITION, VENTILATE AREA. USE APPROPRIATE SAFETY EQUIPMENT TO
ENTER AREA. ALLOW TIME FOR VAPORS TO BE BELOW THEIR TLV. ADD OIL ABSORBENT AND
CLEAN AREA. KEEP PETROLEUM PRODUCTS OUT OF SEWERS AND WATER COURSES.

WASTE DISPOSAL
METHOD:          DO NOT PUNCTURE OR INCINERATE CONTAINERS. GIVE EMPTY, LEAKING 
                 OR FULL CONTAINERS TO A DISPOSAL SERVICE EQUIPPED TO SAFELY 
                 HANDLE AND DISPOSE OF PRESSURIZED CONTAINERS.




             ****SECTION IX. SPECIAL PROTECTION INFORMATION****

RESPIRATORY PROTECTION: NEED APPROVED ORGANIC VAPOR MASK IF TLV IS EXCEEDED.

VENTILATION:
LOCAL EXHAUST:          USED FOR FUMES & TO MAINTAIN BELOW TLV VALUE. 
                        SPECIAL: N/A
MECHANICAL (GENERAL):   OTHER: N/A

PROTECTIVE GLOVES:      USE OIL-RESISTANT GLOVES.

EYE PROTECTION:         USE GOGGLES OR FACE SHIELD. 

OTHER PROTECTIVE
EQUIPMENT:              USE OIL-RESISTANT APRON, IF NEEDED.




                  ****SECTION X. SPECIAL PRECAUTIONS****            
                                                       
PRECAUTIONS TO BE TAKEN
IN HANDLING AND STORING:   STORE IN COOL, DRY AREA OUT OF DIRECT SUNLIGHT. DO 
                           NOT PUNCTURE OR INCINERATE, OR HEAT FULL OR EMPTY 
                           CONTAINERS ABOVE 130 DEGREES F.

OTHER PRECAUTIONS:         PLEASE READ AND FOLLOW THE DIRECTIONS ON THE PRODUCT
                           LABEL. KEEP AWAY FROM CHILDREN.       




                      *****OTHER INFORMATION*****

THE ABOVE INFORMATION IS FURNISHED WITHOUT WARRANTY, EXPRESSED OR IMPLIED,
EXCEPT THAT IT IS ACCURATE TO THE BEST KNOWLEDGE OF FISKE BROTHERS REFINING
COMPANY. THE DATA ON THESE SHEETS RELATES ONLY TO THE SPECIFIC MATERIAL
DESIGNATED HEREIN. FISKE BROTHERS REFINING COMPANY ASSUMES NO LEGAL
RESPONSIBILITY FOR USE OR RELIANCE UPON THIS DATA.
    

The information contained in this MSDS was obtained from current and reliable sources, however, the data is provided without any warrenty, expressed or implied, regarding its correctness or accuracy. Since the conditions or handling, storage and disposal of this product are beyond the control of Imperial Supplies LLC, Imperial will not be responsible for loss, injury, or expense arising out of the products improper use. No warranty, expressed or inferred, regarding the product described in this 'MSDS' shall be created or inferred by any statement in this 'MSDS'. Various government agencies may have specific regulations regarding the transportation, handling, storage, use, or disposal of this product which may not be covered by this 'MSDS'. The user is responsible for full compliance.

Feedback