Product Categories See All
Track Order Status
Sheet 0075190Printer Friendly View
Safety Data Sheet | | Date of Issue: |Revision Date: 8/12/2015 |Revision Number: Imperial Supplies Part Number: 0075190 SECTION 1: IDENTIFICATION 1.1. Product Identifier Product Form: Product Name: Dynatex� 1020 Brake System Silicone Compound CAS No: Synonyms: 1020CL86 1.2. Intended Use of the Product Use of the substance/mixture: Refer to Technical Data. 1.3. Name, Address, and Telephone of the Responsible Party Company Dynatex a division of Soudal Accumetric 350 Ring Road Elizabethtown, KY, 42701 USA Phone: (270) 769-3385 Supplier: Imperial Supplies LLC 1.4. Emergency Telephone Number Emergency |(800) 424-9300 number |CHEMTREC SECTION 2: HAZARDS IDENTIFICATION 2.1. Classification of the Substance or Mixture Classification (GHS-US) N/A | | | 2.2. Label Elements GHS-US Labeling Hazard Pictograms (GHS-US) | | | | | | Signal Word (GHS-US) | Hazard Statements (GHS-US) |N/A Precautionary Statements |Response: N/A (GHS-US) |Prevention: N/A |Storage: N/A |Disposal: N/A 2.3. Other Hazards Other Hazards Not Contributing to the Classification: Not a hazardous substance or mixture. 2.4. Unknown Acute Toxicity (GHS-US) 0% SECTION 3: COMPOSITION/INFORMATION ON INGREDIENTS 3.1. Substance Name |Product identifier |% |Classification | | |(GHS-US) | | | | | | | | | | | | | | | Full text of H-phrases: See Section 16 3.2. Mixture Name |Product identifier |% |Classification | | |(GHS-US) Amorphous fumed silica |112945-52-5 |5% - 15%| | | | | | | | | | | | | SECTION 4: FIRST AID MEASURES 4.1. Description of First Aid Measures First-aid Measures General: Treat according to person's condition and specifics of exposure. First-aid Measures After Inhalation: If symptoms are experienced remove source of contamination or move victim to fresh air. If irritation persists, obtain medical advice. First-aid Measures After Skin Contact: No health effects expected. If irritation does occur, flush with lukewarm, gently flowing water for 5 minutes. If irritation persists, obtain medical advice. First-aid Measures After Eye Contact: If irritation occurs, flush eye(s) with lukewarm, gently flowing water for 5 minutes. Obtain medical attention. First-aid Measures After Ingestion: If irritation or discomfort occur, obtain medical advice. 4.2. Most important symptoms and effects, both acute and delayed Symptoms/Injuries: Symptoms/Injuries After Inhalation: Symptoms/Injuries After Skin Contact: Symptoms/Injuries After Eye Contact: Symptoms/Injuries After Ingestion: Chronic Symptoms: 4.3. Indication of Any Immediate Medical Attention and Special Treatment Needed SECTION 5: FIRE-FIGHTING MEASURES 5.1. Extinguishing Media Suitable Extinguishing Media: On large fires use dry chemical, foam, or water spray. On small fires use carbon dioxide, dry chemical or water spray. Water can be used to cool fire exposed containers. Unsuitable Extinguishing Media: 5.2. Special Hazards Arising From the Substance or Mixture Fire Hazard: Explosion Hazard: Reactivity: 5.3. Advice for Firefighters Precautionary Measures Fire: Firefighting Instructions: Self-contained breathing apparatus and protective clothing should be worn when fighting large fires involving chemicals. Determine the need to evacuate or isolate the area according to your local emergency plan. Use water spray to keep fire exposed containers cool. Protection During Firefighting: SECTION 6: ACCIDENTAL RELEASE MEASURES 6.1. Personal Precautions, Protective Equipment and Emergency Procedures General Measures: 6.1.1. For Non-emergency Personnel Protective Equipment: Emergency Procedures: 6.1.2. For Emergency Responders Protective Equipment: Emergency Procedures: 6.2. Environmental Precautions 6.3. Methods and Material for Containment and Cleaning Up For Containment: Methods for Cleaning Up: Observe all personal protection equipment recommendations in Sections 5 and 8. Wipe or scrape up and contain for salvage or disposal. Clean area as appropriate since spilled materials, even in small quantities, may present a slip hazard. Final cleaning may require use of steam, solvents or detergents. Dispose of saturated absorbent or cleaning materials appropriately, since spontaneous heating may occur. Local, state and federal laws and regulations may apply to releases and disposal of this material, as well as those materials and items employed in the cleanup of releases. You will need to determine which federal, state and local laws and regulations are applicable. Sections 13 and 15 of this MSDS provide information regarding certain federal and state requirements. 6.4. Reference to Other Sections See heading 8, Exposure Controls and Personal Protection. SECTION 7: HANDLING AND STORAGE 7.1. Precautions for Safe Handling Additional Hazards When Processed: Use with adequate ventilation. Avoid eye contact. Hygiene Measures: 7.2. Conditions for Safe Storage, Including Any Incompatibilities Technical Measures: Storage Conditions: Use reasonable care and store away from oxidizing materials. This material in its finely divided form presents an explosion hazard. Follow NFPA 654 (for chemical dusts) or 484 (for metal dusts) as appropriate for managing dust hazards to minimize secondary explosion potential. 7.3. Specific End Use(s) SECTION 8: EXPOSURE CONTROLS/PERSONAL PROTECTION 8.1. Control Parameters Ingredient Name ACGIH TLV OSHA PEL STEL Amorphous fumed silica 10 mg/m3 6 mg/m3 N/A There are no components with workplace exposure limits. These precautions are for room temperature handling. Use at elevated temperatures or aerosol/spray applications may require added precautions. 8.2. Exposure Controls Appropriate Engineering |Local Ventilation: None should be needed. Controls |General Ventilation: Recommended. Personal Protective Equipment|Goggles, Gloves. Materials for Protective | Clothing | Hand Protection |Suitable gloves: Handle in accordance with good |industrial hygiene and safety practices. Eye Protection |Use proper protection - safety glasses as a minimum. | |Avoid eye contact. Use reasonable care. Skin and Body Protection |Washing at mealtime and end of shift is adequate. Respiratory Protection |No respiratory protection should be needed. |Suitable Respirator: None should be needed. Thermal Hazard Protection | SECTION 9: PHYSICAL AND CHEMICAL PROPERTIES 9.1. Information on Basic Physical and Chemical Properties Physical State |Paste Appearance | Odor |Slight, sweet Odor Threshold |N/A pH |Not applicable Relative Evaporation Rate |N/A (butylacetate=1) | Melting Point |Not applicable Freezing Point | Boiling Point |>300C Flash Point |>575 F |FP Method: N/A Auto-ignition Temperature |N/A Decomposition Temperature |N/A Flammability (solid, gas) |N/A Vapor Pressure |N/A Relative Vapor Density at 20 �C |N/A Relative Density | Specific Gravity |1.03 Solubility |Insoluble in water Partition coefficient: |N/A n-octanol/water | Viscosity |Not applicable Lower Flammable Limit |N/A Upper Flammable Limit |N/A 9.2. Other Information VOC%: < 1.5% SECTION 10: STABILITY AND REACTIVITY 10.1 Reactivity 10.2 Chemical Stability Stable. 10.3 Possibility of Hazardous Reactions Hazardous polymerization: Will not occur. 10.4 Conditions to Avoid None known. 10.5 Incompatible Materials Oxidizing material can cause a reaction. 10.6 Hazardous Decomposition Products Thermal breakdown of this product during fire or very high heat conditions may evolve the following hazardous decomposition products: Carbon oxides and traces of incompletely burned carbon compounds Formaldehyde Silicon dioxide. SECTION 11: TOXICOLOGICAL INFORMATION 11.1. Information on Toxicological Effects Acute Toxicity: No known applicable information. Skin Corrosion/Irritation: Serious Eye Damage/Irritation: Respiratory or Skin Sensitization: Germ Cell Mutagenicity: Carcinogenicity: Reproductive Toxicity: Specific Target Organ Toxicity (Single Exposure): Specific Target Organ Toxicity (Repeated Exposure): Aspiration Hazard: Symptoms/Injuries After Inhalation: Symptoms/Injuries After Skin Contact: Symptoms/Injuries After Eye Contact: Symptoms/Injuries After Ingestion: Chronic Symptoms: SECTION 12: ECOLOGICAL INFORMATION 12.1. Toxicity 12.2. Persistence and Degradability 12.3. Bioaccumulative Potential 12.4. Mobility in Soil 12.5. Other Adverse Effects Fate and Effects in Waste Water Treatment Plants: Complete information is not yet available. Environmental Effects Complete information is not yet available. SECTION 13: DISPOSAL CONSIDERATIONS 13.1. Waste treatment methods Waste Disposal Recommendations: We make no guarantee or warranty of any kind that the use or disposal of this product complies with all local, state, or federal laws. It is also the obligation of each user of the product mentioned herein to determine and comply with the requirements of all applicable statutes. This product is not known to be regulated under RCRA regulations. Disposal of unused portions of this product and process waste containing this product should be done only after a careful evaluation and in compliance with all federal, local and state laws. Additional Information: SECTION 14: TRANSPORT INFORMATION 14.1 In Accordance with DOT Proper Shipping Name |Not subject to DOT regulations. Hazard Class | |<PICTOGRAM PHRASE> Identification Number| | Label Codes | | ERG Number | 14.2 In Accordance with IMDG Proper Shipping Name |Not subject to IMDG code. Hazard Class | Identification Number| Label Codes | |<PICTOGRAM PHRASE> ntification Of The | | Substance/m | | EmS-No. (Fire) | | EmS-No. (Spillage) | | 14.3 In Accordance with IATA Proper Shipping Name |Not subject to IATA regulations. Identification Number| |<PICTOGRAM PHRASE> Hazard Class | | Label Codes | | ntification Of The | | Substance/m | | ERG Code (IATA) | SECTION 15: REGULATORY INFORMATION 15.1 US Federal Regulations The contents of this MSDS comply with the OSHA Hazard Communication Standard 29 CFR 1910.1200. SARA Section 311/312 Hazard Classes |Acute: No |Chronic: No |Fire: No |Pressure: No |Reactive: No Toxic Substances Control Act (TSCA) |All chemical substances found in this product |comply with the Toxic Substances Control Act |inventory reporting requirements. 15.2 US State Regulations SARA Title III Section 302 Extremely Hazardous Substances: None. SARA Title III Section 304 CERCLA Substances danger uses: None. SARA Title III Section 313 Toxic Chemicals: None present or none present in regulated quantities. Note: Chemicals are listed under the 313 Toxic Chemicals section only if they meet or exceed a reporting threshold. California Proposition 65: This product contains the following chemical(s) listed by the State of California under the Safe Drinking Water and Toxic Enforcement Act of 1986 (Proposition 65) as being known to cause cancer, birth defects or other reproductive harm: None known. Massachusetts: Silica, amorphous (7631-86-9) New Jersey: Polydimethylsiloxane (63148-62-9) Silica, amorphous (7631-86-9) Dimethyl siloxane, hydroxy-terminated (70131-67-8) Pennsylvania Polydimethylsiloxane (63148-62-9) Silica, amorphous (7631-86-9) Dimethyl siloxane, hydroxy-terminated (70131-67-8) SECTION 16: OTHER INFORMATION, INCLUDING DATE OF PREPARATION OR LAST REVISION Revision date |8/12/2015 Other |This document has been prepared in accordance with the SDS Information |requirements of the OSHA Hazard Communication Standard 29 CFR |1910.1200. GHS Full Text Phrases: ----| | -- | | ----| | -- | | ----| | -- | | ----| | -- | | ----| | -- | | Grainger disclaimer.
The information contained in this was obtained from current and reliable sources, however, the data is provided without any warrenty, expressed or implied, regarding its correctness or accuracy. Since the conditions or handling, storage and disposal of this product are beyond the control of Imperial Supplies LLC, Imperial will not be responsible for loss, injury, or expense arising out of the products improper use. No warranty, expressed or inferred, regarding the product described in this '' shall be created or inferred by any statement in this ''. Various government agencies may have specific regulations regarding the transportation, handling, storage, use, or disposal of this product which may not be covered by this ''. The user is responsible for full compliance.