Product Categories See All
Track Order Status
SDS Sheet 0072180Printer Friendly View
SECTION 1: IDENTIFICATION 1.1. Product Identifier Product Form: Product Name: A00166 MST ASPIRE HD MP CLNR 20N16 CAS No: Synonyms: 1.2. Intended Use of the Product Use of the substance/mixture: 1.3. Name, Address, and Telephone of the Responsible Party Company : Zep Inc. 1310 Seaboard Industrial Blvd., NW Atlanta, GA 30318 Phone: 404-352-1680 1.4. Emergency Telephone Number Emergency | 1-877-428-9937, 877-541-2016, 800-424-9300, 202-483-7616 number | SECTION 2: HAZARDS IDENTIFICATION 2.1. Classification of the Substance or Mixture Classification (GHS-US) Gases under |Liquefied gas pressure | | | 2.2. Label Elements GHS-US Labeling Hazard Pictograms (GHS-US) |Gas Cylinder Signal Word (GHS-US) |Warning Hazard Statements (GHS-US) |H280 Contains gas under pressure; may explode if |heated. Precautionary Statements |Storage: (GHS-US) |P410 + P403 Protect from sunlight. Store in a |well-ventilated place. 2.3. Other Hazards Other Hazards Not Contributing to the Classification: 2.4. Unknown Acute Toxicity (GHS-US) SECTION 3: COMPOSITION/INFORMATION ON INGREDIENTS 3.1. Substance Name |Product identifier |% |Classification | | |(GHS-US) | | | | | | | | | | | | | | | Full text of H-phrases: See Section 16 3.2. Mixture Name |Product identifier |% |Classification | | |(GHS-US) butane |106-97-8 |>= 1 - <| | |5 | | | | | | | | | | | | | SECTION 4: FIRST AID MEASURES 4.1. Description of First Aid Measures First-aid Measures General: Do not leave the victim unattended. Move out of dangerous area. Show this safety data sheet to the doctor in attendance. First-aid Measures After Inhalation: If unconscious place in recovery position and seek medical advice. If symptoms persist, call a physician. First-aid Measures After Skin Contact: Take off contaminated clothing and shoes immediately. Get medical attention if irritation develops and persists. Wash contaminated clothing before re-use. Wash off immediately with plenty of water for at least 15 minutes. First-aid Measures After Eye Contact: Remove contact lenses. Protect unharmed eye. Keep eye wide open while rinsing. If eye irritation persists, consult a specialist. If in eyes, rinse with water for 15 minutes. First-aid Measures After Ingestion: Keep respiratory tract clear. Never give anything by mouth to an unconscious person. If symptoms persist, call a physician. DO NOT induce vomiting unless directed to do so by a physician or poison control center. 4.2. Most important symptoms and effects, both acute and delayed Symptoms/Injuries: Symptoms/Injuries After Inhalation: Symptoms/Injuries After Skin Contact: Symptoms/Injuries After Eye Contact: Symptoms/Injuries After Ingestion: Chronic Symptoms: 4.3. Indication of Any Immediate Medical Attention and Special Treatment Needed SECTION 5: FIRE-FIGHTING MEASURES 5.1. Extinguishing Media Suitable Extinguishing Media: Dry chemical Water spray jet Carbon dioxide (CO2) Alcohol-resistant foam. Unsuitable Extinguishing Media: High volume water jet. 5.2. Special Hazards Arising From the Substance or Mixture Fire Hazard: Carbon dioxide (CO2). Carbon monoxide. Smoke. Explosion Hazard: Do not allow run-off from fire fighting to enter drains or water courses. Reactivity: 5.3. Advice for Firefighters Precautionary Measures Fire: Firefighting Instructions: Use extinguishing measures that are appropriate to local circumstances and the surrounding environment. Further information: For safety reasons in case of fire, cans should be stored separately in closed containments. Fire residues and contaminated fire extinguishing water must be disposed of in accordance with local regulations. Collect contaminated fire extinguishing water separately. This must not be discharged into drains. Use a water spray to cool fully closed containers. Protection During Firefighting: Wear self-contained breathing apparatus for firefighting if necessary. SECTION 6: ACCIDENTAL RELEASE MEASURES 6.1. Personal Precautions, Protective Equipment and Emergency Procedures General Measures: Use personal protective equipment. Ensure adequate ventilation. Evacuate personnel to safe areas. Remove all sources of ignition. Beware of vapours accumulating to form explosive concentrations. Vapours can accumulate in low areas. 6.1.1. For Non-emergency Personnel Protective Equipment: Emergency Procedures: 6.1.2. For Emergency Responders Protective Equipment: Emergency Procedures: 6.2. Environmental Precautions Prevent further leakage or spillage if safe to do so. 6.3. Methods and Material for Containment and Cleaning Up For Containment: Methods for Cleaning Up: Sweep up or vacuum up spillage and collect in suitable container for disposal. Soak up with inert absorbent material (e.g. sand, silica gel, acid binder, universal binder, sawdust). 6.4. Reference to Other Sections See heading 8, Exposure Controls and Personal Protection. SECTION 7: HANDLING AND STORAGE 7.1. Precautions for Safe Handling Additional Hazards When Processed: For personal protection see section 8. Smoking, eating and drinking should be prohibited in the application area. Dispose of rinse water in accordance with local and national regulations. Always replace cap after use. Do not breathe vapours or spray mist. Hygiene Measures: Wash hands before breaks and at the end of workday. 7.2. Conditions for Safe Storage, Including Any Incompatibilities Technical Measures: Storage Conditions: BEWARE: Aerosol is pressurized. Keep away from direct sun exposure and temperatures over 50 Â°C. Do not open by force or throw into fire even after use. Do not spray on flames or red-hot objects. Observe label precautions. Keep in a dry, cool and well-ventilated place. Electrical installations / working materials must comply with the technological safety standards. No smoking. Materials to avoid: Oxidizing agents. 7.3. Specific End Use(s) SECTION 8: EXPOSURE CONTROLS/PERSONAL PROTECTION 8.1. Control Parameters Components CAS-No. Value type (Form of exposure) Control parameters / Permissible concentration Basis butane 106-97-8 TWA 800 ppm 1,900 mg/m3 NIOSH REL TWA 800 ppm 1,900 mg/m3 OSHA P0 8.2. Exposure Controls Appropriate Engineering | Controls | Personal Protective Equipment| Materials for Protective | Clothing | Hand Protection |Remarks: The suitability for a specific workplace |should be discussed with the producers of the |protective gloves. Eye Protection |Ensure that eyewash stations and safety showers are |close to the workstation location. Tightly fitting |safety goggles. Skin and Body Protection |Impervious clothing. Choose body protection |according to the amount and concentration of the |dangerous substance at the work place. Respiratory Protection |In case of insufficient ventilation, wear suitable |respiratory equipment. Thermal Hazard Protection | SECTION 9: PHYSICAL AND CHEMICAL PROPERTIES 9.1. Information on Basic Physical and Chemical Properties Physical State | Appearance |Aerosol containing a liquefied gas Odor |like fruit Odor Threshold |no data available pH |9.5 - 10.5 Relative Evaporation Rate |no data available (butylacetate=1) | Melting Point |no data available Freezing Point |no data available Boiling Point |no data available Flash Point |not applicable Auto-ignition Temperature |not determined Decomposition Temperature |no data available Flammability (solid, gas) |The product is not flammable. Vapor Pressure |no data available Relative Vapor Density at 20 Â°C |no data available Relative Density | Specific Gravity | Solubility |no data available Partition coefficient: |no data available n-octanol/water | Viscosity |Viscosity, kinematic: no data available. Lower Flammable Limit |no data available Upper Flammable Limit |no data available 9.2. Other Information SECTION 10: STABILITY AND REACTIVITY 10.1 Reactivity Stable. 10.2 Chemical Stability Stable under normal conditions. 10.3 Possibility of Hazardous Reactions Vapours may form explosive mixture with air. No decomposition if stored and applied as directed. 10.4 Conditions to Avoid Heat, flames and sparks. Extremes of temperature and direct sunlight. 10.5 Incompatible Materials Oxidizing agents. 10.6 Hazardous Decomposition Products Carbon oxides. SECTION 11: TOXICOLOGICAL INFORMATION 11.1. Information on Toxicological Effects Acute Toxicity: Skin Corrosion/Irritation: no data available. Serious Eye Damage/Irritation: no data available. Respiratory or Skin Sensitization: no data available. Germ Cell Mutagenicity: no data available. Carcinogenicity: no data available. Reproductive Toxicity: no data available. Specific Target Organ Toxicity (Single Exposure): no data available. Specific Target Organ Toxicity (Repeated Exposure): no data available. Aspiration Hazard: no data available. Symptoms/Injuries After Inhalation: Symptoms/Injuries After Skin Contact: Symptoms/Injuries After Eye Contact: Symptoms/Injuries After Ingestion: Chronic Symptoms: SECTION 12: ECOLOGICAL INFORMATION 12.1. Toxicity no data available. 12.2. Persistence and Degradability no data available. 12.3. Bioaccumulative Potential Product: Partition coefficient: n-octanol/water: Remarks: no data available. Components: butane : Partition coefficient: n-octanol/water: Pow: 2.89. 12.4. Mobility in Soil no data available. 12.5. Other Adverse Effects no data available. Product: Regulation: 40 CFR Protection of Environment; Part 82 Protection of Stratospheric Ozone - CAA Section 602 Class I Substances. Remarks: This product neither contains, nor was manufactured with a Class I or Class II ODS as defined by the U.S. Clean Air Act Section 602 (40 CFR 82, Subpt. A, App.A + B). Additional ecological information : no data available. SECTION 13: DISPOSAL CONSIDERATIONS 13.1. Waste treatment methods Waste Disposal Recommendations: Do not dispose of waste into sewer. Do not contaminate ponds, waterways or ditches with chemical or used container. The product should not be allowed to enter drains, water courses or the soil. Additional Information: Contaminated packaging: Empty remaining contents. Dispose of as unused product. Do not re-use empty containers. Do not burn, or use a cutting torch on, the empty drum. SECTION 14: TRANSPORT INFORMATION 14.1 In Accordance with DOT Proper Shipping Name | Hazard Class | |<PICTOGRAM PHRASE> Identification Number| | Label Codes | | ERG Number | 14.2 In Accordance with IMDG Proper Shipping Name |Vessel: AEROSOLS, NON-FLAMMABLE Hazard Class |2.2 Identification Number|UN1950 Label Codes | |<PICTOGRAM PHRASE> ntification Of The | | Substance/m | | EmS-No. (Fire) | | EmS-No. (Spillage) | | 14.3 In Accordance with IATA Proper Shipping Name |Cargo Air: AEROSOLS, NON-FLAMMABLE |Passenger Air: AEROSOLS, NON-FLAMMABLE Identification Number|UN1950 |<PICTOGRAM PHRASE> Hazard Class |2.2 | Label Codes | | ntification Of The | | Substance/m | | ERG Code (IATA) | SECTION 15: REGULATORY INFORMATION 15.1 US Federal Regulations <COMPONENT> EPCRA - Emergency Planning and Community Right-to-Know Act: CERCLA Reportable Quantity: This material does not contain any components with a CERCLA RQ. SARA 304 Extremely Hazardous Substances Reportable Quantity: This material does not contain any components with a section 304 EHS RQ. SARA 302: SARA 302: No chemicals in this material are subject to the reporting requirements of SARA Title III, Section 302. SARA 313: SARA 313: This material does not contain any chemical components with known CAS numbers that exceed the threshold (De Minimis) reporting levels established by SARA Title III, Section 313. SARA Section 311/312 Hazard Classes |Sudden Release of Pressure Hazard Toxic Substances Control Act (TSCA) |On TSCA Inventory 15.2 US State Regulations <COMPONENT> California Prop 65: This product does not contain any chemicals known to State of California to cause cancer, birth defects, or any other reproductive harm. SECTION 16: OTHER INFORMATION, INCLUDING DATE OF PREPARATION OR LAST REVISION Revision date |02/18/2015 Other |This document has been prepared in accordance with the SDS Information |requirements of the OSHA Hazard Communication Standard 29 CFR |1910.1200. GHS Full Text Phrases: ----|Hazard statements: |Contains gas under pressure; may explode if -- | |heated. ----|Precautionary statements: |Storage: -- | |Protect from sunlight. Store in a | |well-ventilated place. ----| | -- | | ----| | -- | | ----| | -- | | Grainger disclaimer.
The information contained in this SDS was obtained from current and reliable sources, however, the data is provided without any warrenty, expressed or implied, regarding its correctness or accuracy. Since the conditions or handling, storage and disposal of this product are beyond the control of Imperial Supplies LLC, Imperial will not be responsible for loss, injury, or expense arising out of the products improper use. No warranty, expressed or inferred, regarding the product described in this 'SDS' shall be created or inferred by any statement in this 'SDS'. Various government agencies may have specific regulations regarding the transportation, handling, storage, use, or disposal of this product which may not be covered by this 'SDS'. The user is responsible for full compliance.