Product Categories See All
Track Order Status
SDS Sheet 0067930Printer Friendly View
SECTION 1: IDENTIFICATION 1.1. Product Identifier Product Form: Product Name: CorrosionXÂ® CAS No: Synonyms: 1.2. Intended Use of the Product Use of the substance/mixture: Corrosion Inhibitor / Moisture Displacer / Lubricant 1.3. Name, Address, and Telephone of the Responsible Party Company U.S. Corrosion Technologies, LLC 2638 National Drive, Garland, TX 75041 Phone: 972-271-7361 1.4. Emergency Telephone Number Emergency |CHEMTRECÂ® USA (800) 424-9300 number |Outside US (703) 927-3887 SECTION 2: HAZARDS IDENTIFICATION 2.1. Classification of the Substance or Mixture Classification (GHS-US) Eye Irritation|Category 2B Inhalation |Category 4 Aspiration |Category 1 Hazard | 2.2. Label Elements GHS-US Labeling Hazard Pictograms (GHS-US) |Exclamation Mark |Health Hazard Signal Word (GHS-US) |DANGER Hazard Statements (GHS-US) |Causes eye irritation |Harmful if inhaled |May be fatal if swallowed and enters airways Precautionary Statements |Use only outdoors or in a well-ventilated area. (GHS-US) |Avoid breathing mist. Store locked up. Dispose of |contents and container in accordance with local |regulations. |If in eyes: Rinse cautiously with water for several |minutes. Remove contact lenses, if present and easy |to do. Continue rinsing. |If eye irritation persists: Get medical |advice/attention. |If inhaled: Remove person to fresh air and keep |comfortable for breathing. Call a doctor if you feel |unwell. |If swallowed: Immediately call a doctor or poison |center. Do NOT induce vomiting. 2.3. Other Hazards Other Hazards Not Contributing to the Classification: 2.4. Unknown Acute Toxicity (GHS-US) SECTION 3: COMPOSITION/INFORMATION ON INGREDIENTS 3.1. Substance Name |Product identifier |% |Classification | | |(GHS-US) | | | | | | | | | | | | | | | Full text of H-phrases: See Section 16 3.2. Mixture Name |Product identifier |% |Classification | | |(GHS-US) Hydrotreated light petroleum |64742-47-8 |7-10* | distillates | | | Mineral oil |8042-47-5 |10-15* | Hydrotreated neutral base oil |72623-85-9 |65-75* | | | | | | | * Exact percentage of composition has been withheld as a trade secret SECTION 4: FIRST AID MEASURES 4.1. Description of First Aid Measures First-aid Measures General: Causes eye irritation. Avoid eye contact. Aspiration hazard; do not swallow. May cause lung damage. Use with adequate ventilation. Avoid breathing mist. Prolonged or repeated inhalation may cause dizziness and drowsiness. Keep container closed. First-aid Measures After Inhalation: Remove from exposure area. Remove to fresh air. Give artificial respiration if not breathing. Get medical attention. First-aid Measures After Skin Contact: Wipe excess from skin; remove contaminated clothing. Wash with soap and water. First-aid Measures After Eye Contact: Flush eyes with plenty of water for 15 minutes while holding eyelids open. Seek medical attention if irritation persists. First-aid Measures After Ingestion: Give water, DO NOT induce vomiting. No treatment necessary unless large quantities are ingested, then seek medical advice. 4.2. Most important symptoms and effects, both acute and delayed Symptoms/Injuries: Symptoms/Injuries After Inhalation: Symptoms/Injuries After Skin Contact: Symptoms/Injuries After Eye Contact: Symptoms/Injuries After Ingestion: Chronic Symptoms: 4.3. Indication of Any Immediate Medical Attention and Special Treatment Needed SECTION 5: FIRE-FIGHTING MEASURES 5.1. Extinguishing Media Suitable Extinguishing Media: Carbon Dioxide, Dry Chemical, and Foam Unsuitable Extinguishing Media: Alcohol, Alcohol based solutions, any other media not listed above. 5.2. Special Hazards Arising From the Substance or Mixture Fire Hazard: Explosion Hazard: Solvent vapors are heavier than air and may travel to distant, low lying sources of ignition and may ignite and explode. Reactivity: 5.3. Advice for Firefighters Precautionary Measures Fire: Firefighting Instructions: As in any fire, wear self-contained breathing apparatus, pressure-demand, MSHA/NIOSH (approved or equivalent) and full protective gear. Protection During Firefighting: SECTION 6: ACCIDENTAL RELEASE MEASURES 6.1. Personal Precautions, Protective Equipment and Emergency Procedures General Measures: Use caution as spills may be slippery. Ensure adequate ventilation. Use personal protective equipment. Remove all sources of ignition and take precautionary measures against static discharges. 6.1.1. For Non-emergency Personnel Protective Equipment: Emergency Procedures: 6.1.2. For Emergency Responders Protective Equipment: Emergency Procedures: 6.2. Environmental Precautions 6.3. Methods and Material for Containment and Cleaning Up For Containment: Do not flush into surface water or sanitary sewer system. Dike and contain spillage. Soak up with non-combustible absorbent material, (e.g. sand, earth, diatomaceous earth, vermiculite). Methods for Cleaning Up: Use clean non-sparking tools to collect absorbed material and transfer to a properly labeled container for disposal according to local / national regulations. 6.4. Reference to Other Sections See heading 8, Exposure Controls and Personal Protection. SECTION 7: HANDLING AND STORAGE 7.1. Precautions for Safe Handling Additional Hazards When Processed: Avoid eye contact. Use with adequate ventilation. Avoid breathing mist. Follow all SDS/label precautions even after container is empty due to residue. Hygiene Measures: Avoid eye contact. Always wash hands and face before eating, drinking or smoking. Remove and wash contaminated clothing before re-use. 7.2. Conditions for Safe Storage, Including Any Incompatibilities Technical Measures: Storage Conditions: Conditions to avoid: Store in a cool, dry, well-ventilated place in the original container. Keep container tightly closed when not in use. Avoid excess heating, high temperatures, sparks, hot surfaces, open flames, and all other sources of ignition. 7.3. Specific End Use(s) SECTION 8: EXPOSURE CONTROLS/PERSONAL PROTECTION 8.1. Control Parameters Component ACGIH OSHA TLV TLV PEL PEL STEL STEL ppm mg/m3 ppm mg/m3 ppm mg/m3 Hydrotreated light petroleum distillates 100 - - - 500 - Mineral Oil - 5 10 5 - 10 Hydrotreated neutral base oil - 5 10 5 - 10 8.2. Exposure Controls Appropriate Engineering |Use with local exhaust ventilation. Ensure adequate Controls |ventilation, especially in confined areas. Personal Protective Equipment| Materials for Protective | Clothing | Hand Protection | Eye Protection |Safety glasses with side-shields. An eyewash station |should be available to the area of use. Skin and Body Protection |None required under normal use conditions. Wear |impermeable gloves such as neoprene or nitrile |rubber gloves, gauntlets and apron depending on the |extent and duration of exposure. Respiratory Protection |None required under normal use conditions. In case |of insufficient ventilation and for exposures above |occupational exposure limits wear a NIOSH approved |air purifying respirator with organic vapor |cartridge. Thermal Hazard Protection | SECTION 9: PHYSICAL AND CHEMICAL PROPERTIES 9.1. Information on Basic Physical and Chemical Properties Physical State |Non-viscous liquid Appearance |Transparent Odor |Fresh scent Odor Threshold | pH |6.9 Relative Evaporation Rate |<0.01 (butylacetate=1) | Melting Point |Not established Freezing Point | Boiling Point |>400Â°F / 204Â°C Flash Point |132Â°C / 270Â°F Auto-ignition Temperature |Not established Decomposition Temperature | Flammability (solid, gas) | Vapor Pressure |>1 mmHg @23Â°C Relative Vapor Density at 20 Â°C | Relative Density | Specific Gravity |0.895 Solubility |Insoluble in water Partition coefficient: | n-octanol/water | Viscosity |cSt @ 40Â°C: 33.2 |cSt @ 100Â°C: 7.0 Lower Flammable Limit |4.8 Upper Flammable Limit |7 9.2. Other Information VOC Content g/l (%): 82 (5) SECTION 10: STABILITY AND REACTIVITY 10.1 Reactivity 10.2 Chemical Stability Stable at ambient temperatures. 10.3 Possibility of Hazardous Reactions 10.4 Conditions to Avoid Excess heating above 356Â°F / 180Â°C over long periods of time degrades the resin. Avoid high temperatures, sparks, open flame, and all other sources of ignition. 10.5 Incompatible Materials 10.6 Hazardous Decomposition Products SECTION 11: TOXICOLOGICAL INFORMATION 11.1. Information on Toxicological Effects Acute Toxicity: Skin Corrosion/Irritation: Serious Eye Damage/Irritation: Respiratory or Skin Sensitization: Germ Cell Mutagenicity: Carcinogenicity: Not established Reproductive Toxicity: Specific Target Organ Toxicity (Single Exposure): Eyes, lungs. Specific Target Organ Toxicity (Repeated Exposure): Aspiration Hazard: Symptoms/Injuries After Inhalation: Coughing/Sneezing, Dizziness Symptoms/Injuries After Skin Contact: Skn-Rbt - 20,000 mg/kg Symptoms/Injuries After Eye Contact: Eye Irritation Symptoms/Injuries After Ingestion: Orl-rat LD50 >5000 mg/kg Chronic Symptoms: None known SECTION 12: ECOLOGICAL INFORMATION 12.1. Toxicity 12.2. Persistence and Degradability 12.3. Bioaccumulative Potential 12.4. Mobility in Soil 12.5. Other Adverse Effects Biodegradation under aerobic static laboratory conditions is below detectable limits (i.e. BOD less than 2.5% of theoretical) in 20 days. SECTION 13: DISPOSAL CONSIDERATIONS 13.1. Waste treatment methods Waste Disposal Recommendations: Dispose of in accordance with local regulations. Smaller quantities can be disposed of with household waste. Additional Information: Container: Empty remaining contents. Empty containers should be taken for local recycling, recovery, or waste disposal. Empty containers may contain residues. Do not cut, weld or grind empty containers. SECTION 14: TRANSPORT INFORMATION 14.1 In Accordance with DOT Proper Shipping Name | Hazard Class |Non-Hazardous/ |<PICTOGRAM PHRASE> |Non-Restricted | Identification Number| | Label Codes | | ERG Number | 14.2 In Accordance with IMDG Proper Shipping Name | Hazard Class |Non-Hazardous/ Non-Restricted Identification Number| Label Codes | |<PICTOGRAM PHRASE> ntification Of The | | Substance/m | | EmS-No. (Fire) | | EmS-No. (Spillage) | | 14.3 In Accordance with IATA Proper Shipping Name | Identification Number| |<PICTOGRAM PHRASE> Hazard Class |Non-Hazardous/ | |Non-Restricted | Label Codes | | ntification Of The | | Substance/m | | ERG Code (IATA) | SECTION 15: REGULATORY INFORMATION 15.1 US Federal Regulations <COMPONENT> SARA Section 311/312 Hazard Classes |X Immediate Hazard |Delayed Hazard |Fire Hazard |Pressure Hazard |Reactivity Hazard Toxic Substances Control Act (TSCA) |All components are included on the Inventory 15.2 US State Regulations <COMPONENT> SECTION 16: OTHER INFORMATION, INCLUDING DATE OF PREPARATION OR LAST REVISION Revision date |2/3/2015 Other |This document has been prepared in accordance with the SDS Information |requirements of the OSHA Hazard Communication Standard 29 CFR |1910.1200. GHS Full Text Phrases: ----| | -- | | ----| | -- | | ----| | -- | | ----| | -- | | ----| | -- | | Grainger disclaimer.
The information contained in this SDS was obtained from current and reliable sources, however, the data is provided without any warrenty, expressed or implied, regarding its correctness or accuracy. Since the conditions or handling, storage and disposal of this product are beyond the control of Imperial Supplies LLC, Imperial will not be responsible for loss, injury, or expense arising out of the products improper use. No warranty, expressed or inferred, regarding the product described in this 'SDS' shall be created or inferred by any statement in this 'SDS'. Various government agencies may have specific regulations regarding the transportation, handling, storage, use, or disposal of this product which may not be covered by this 'SDS'. The user is responsible for full compliance.