Product Categories See All
Track Order Status
MSDS Sheet 0066210Printer Friendly View
MATERIAL SAFETY DATA SHEET SB-6-665 DATE OF PREPARATION 03 00 Mar 16, 2009 SECTION 1- PRODUCT AND COMPANY IDENTIFICATION PRODUCT NUMBER SB-6-665 PRODUCT NAME SPRAYON Red Epoxy Insulating Enamel MANUFACTURER'S NAME THE SHERWIN-WILLIAMS COMPANY KRYLON PRODUCTS GROUP Cleveland, OH 44115 Telephone Numbers and Websites Product Information (800) 251-2486 www.kpg-industrial.com Regulatory Information (216) 566-2902 www.paintdocs.com Medical Emergency (216) 566-2917 Transportation Emergency* (800) 424-9300 *for Chemical Emergency ONLY (spill, leak, fire, exposure, or accident) SECTION 2- COMPOSITION/INFORMATION ON INGREDIENTS % by Weight CAS Number Ingredient Units Vapor Pressure 14 74-98-6 Propane ACGIH TLV 2500 PPM 760 mm OSHA PEL 1000 PPM 13 106-97-8 Butane ACGIH TLV 800 PPM 760 mm OSHA PEL 800 PPM 12 108-88-3 Toluene ACGIH TLV 20 PPM 22 mm OSHA PEL 100 PPM (skin) OSHA PEL 150 PPM (skin) STEL 2 100-41-4 Ethylbenzene ACGIH TLV 100 PPM 7.1 mm ACGIH TLV 125 PPM STEL OSHA PEL 100 PPM OSHA PEL 125 PPM STEL 13 1330-20-7 Xylene ACGIH TLV 100 PPM 5.9 mm ACGIH TLV 150 PPM STEL OSHA PEL 100 PPM OSHA PEL 150 PPM STEL 22 67-64-1 Acetone ACGIH TLV 500 PPM 180 mm ACGIH TLV 750 PPM STEL OSHA PEL 1000 PPM 4 471-34-1 Calcium Carbonate ACGIH TLV 10 mg/m3 as Dust OSHA PEL 15 mg/m3 Total Dust OSHA PEL 5 mg/m3 Respirable Fraction SECTION 3-HAZARDS IDENTIFICATION HMIS CODES Health 2* Flammability 3 Reactivity 0 ROUTES OF EXPOSURE INHALATION of Vapor or spray mist. EYE or SKIN contact with the product, vapor or spray mist. EFFECTS OF EXPOSURE EYES: Irritation SKIN: Prolonged or repeated exposure may cause irritation. INHALATION: Irritation of the upper respiratory system. May cause nervous system depression. Extreme overexposure may result in unconsciousness and possibly death. Prolonged overexposure to solvent ingredients in Section 2 may cause adverse effects to the liver, urinary, cardiovascular and reproductive systems. SIGNS AND SYMPTOMS OF OVEREXPOSURE Headache, dizziness, nausea, and loss of coordination are indications of excessive exposure to vapors or spray mists. Redness and itching or burning sensation may indicate eye or excessive skin irritation. MEDICAL CONDITIONS AGGRAVATED BY EXPOSURE None generally recognized. CANCER INFORMATION For complete discussion of toxicology data refer to Section 11. SECTION 4-FIRST AID MEASURES EYES: Flush eyes with large amounts of water for 15 minutes. Get medical attention. SKIN: Wash affected area thoroughly with soap and water. Remove contaminated clothing and launder before re-use. INHALATION: If affected, remove from exposure. Restore breathing. Keep warm and quiet. INGESTION: Do not induce vomiting. Get medical attention immediately. SECTION 5-FIRE FIGHTING MEASURES FLASHPOINT LEL UEL EXTINGUISHING MEDIA Propellant < 0 F 1.0 12.8 Carbon Dioxide, Dry Chemical, Foam UNUSUAL FIRE AND EXPLOSION HAZARDS Containers may explode when exposed to extreme heat. Application to hot surfaces requires special precautions. During emergency conditions overexposure to decomposition products may cause a health hazard. Symptoms may not be immediately apparent. Obtain medical attention. SPECIAL FIRE FIGHTING PROCEDURES Full protective equipment including self-contained breathing apparatus should be used. Water spray may be ineffective. If water is used, fog nozzles are preferable. Water may be used to cool closed containers to prevent pressure build-up and possible auto ignition or explosion when exposed to extreme heat. SECTION 6-ACCIDENTAL RELEASE MEASURES STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED --Remove all sources of ignition. Ventilate the area. --Remove with inert absorbent. SECTION 7- HANDLING AND STORAGE STORAGE CATEGORY Not Available PRECAUTIONS TO BE TAKEN IN HANDLING AND STORAGE Keep away from heat, sparks, and open flame. Vapors will accumulate readily and may ignite explosively. During use and until all vapors are gone: Keep area ventilated-Do not smoke- Extinguish all flames, pilot lights, and heaters - Turn off stoves, electric tools and appliances, and any other sources of ignition. Consult NFPA Code. Use approved Bonding and Grounding procedures. Contents under pressure. Do not puncture, incinerate, or expose to temperature above 120F. Heat from sunlight, radiators, stoves, hot water, and other heat sources could cause container to burst. Do not take internally. Keep out of reach of children. SECTION 8- EXPOSURE CONTROLS/PERSONAL PROTECTION PRECAUTIONS TO BE TAKEN IN USE Use only with adequate ventilation. Avoid contact with skin and eyes. Avoid breathing vapor and spray mist. Wash hands after using. This coating may contain materials classified as nuisance particulates (listed "as Dust" in Section 2) which may be present at hazardous levels only during sanding or abrading of the dried film. If no specific dusts are listed in Section 2, the applicable limits for nuisance dusts are ACGIH TLV 10 mg/m3 (total dust), 3 mg/m3 (respirable fraction), OSHA PEL 15 mg/m3 (total dust), 5 mg/m3 (respirable fraction). VENTILATION Local exhaust preferable. General exhaust acceptable if the exposure to materials in Section 2 is maintained below applicable exposure limits. Refer to OSHA standards 1910.94, 1910.107, and 1910.108. RESPIRATORY PROTECTION If personal exposure cannot be controlled below applicable limits by ventilation, wear a properly fitted organic vapor/particulate respirator approved by NIOSH/MSHA for protection against materials in Section 2. When sanding or abrading the dried film, wear a dust/mist respirator approved by NIOSH/MSHA for dust which may be generated for this product, underlying paint, or the abrasive. PROTECTIVE GLOVES None required for normal application of aerosol products where minimal skin contact is expected. For long or repeated contact, wear chemical resistant gloves. EYE PROTECTION Wear safety spectacles with unperforated side shields. OTHER PRECAUTIONS Intentional misuse by deliberately concentrating and inhaling the contents can be harmful or fatal. SECTION 9-PHYSICAL AND CHEMICAL PROPERTIES PRODUCT WEIGHT 6.59 lb/gal 789 g/l SPECIFIC GRAVITY 0.79 BOILING POINT <0 - 292 F <-18 -144 C MELTING POINT Not Available VOLATILE VOLUME 88% EVAPORATION RATE Faster than ether VAPOR DENSITY Heavier than air SOLUBILITY INWATER N.A. VOLATILE ORGANIC COMPOUNDS (VOC Theoretical-As Packaged) Volatile Weight 55.80% Less Water and Federally Exempt Solvents SECTION 10-STABILITY AND REACTIVITY STABILITY-Stable CONDITIONS TO AVOID None Known. INCOMPATIBILITY None known. HAZARDOUOS DECOMPOSITION PRODUCTS By fire: Carbon Dioxide, Carbon Monoxide HAZARDOUS POLYMERIZATION Will not occur SECTION 11-TOXICOLOGICAL INFORMATION CHRONIC HEALTH HAZARDS Reports have associated repeated and prolonged overexposure to solvents with permanent brain and nervous system damage. Ethylbenzene is classified by IARC as possibly carcinogenic to humans (2B) based on inadequate evidence in humans and sufficient evidence in laboratory animals. Lifetime inhalation exposure of rats and mice to high ethylbenzene concentrations resulted in increase in certain types of cancer, including kidney tumors in rats and lung and liver tumors in mice. These effects were not observed in animals exposed to lower concentrations. There is no evidence that ethylbenzene causes cancer in humans. TOXICOLOGY DATA CAS No. Ingredient Name 74-98-6 Propane LC50 RAT 4HR Not Available LD50 RAT Not Available 106-97-8 Butane LC50 RAT 4HR Not Available LD50 RAT Not Available 108-88-3 Toluene LD50 RAT 4HR 4000 ppm LD50 RAT 5000 mg/kg 100-41-4 Ethylbenzene LC50 RAT 4HR Not Available LD50 RAT 3500 mg/kg 1330-20-7 Xylene LD50 RAT 4HR 5000 ppm LD50 RAT 4300 mg/kg 67-64-1 Acetone LC50 RAT 4HR Not Available LD50 RAT 5800 mg/kg 471-34-1 Calcium LD50 RAT 4HR Not Available Carbonate LD50 RAT Not Available SECTION 12-ECOLGICAL INFORMATION ECOTOXICOLOGICAL INFORMATION No data available. SECTION 13-DISPOSAL CONSIDERATIONS WASTE DISPOSAL METHOD Waste from this product may be hazardous as defined under the Resource conservation and Recovery Act (RCRA) 40 CRF 261. Waste must be tested for ignitability to determine the applicable EPA hazardous waste numbers. Do not incinerate. Depressurize container. Dispose of in accordance with Federal, State/Provincial, and Local regulations regarding pollution. SECTION 14-TRANSPORT INFORMATION US Ground (DOT) May be classed as Consumer Commodity, ORM-D UN1950, AEROSOLS, 2.1, LIMITED QUANTITY, (ERG#126) Canada (TDG) May be classed as Consumer Commodity, ORM-D UN1950 AEROSOLS, CLASS 2.1, LIMITED QUANTITY, (ERG#126) IMO May be shipped as Limited Quantity UN1950, AEROSOLS, CLASS 2.1, LIMITED QUANTITY, EmS F-D, S-U SECTION 15-REGULATORY INFORMATION SARA 313 (40CFR 372.65C) SUPPLIER NOTIFICATION CAS No. CHEMICAL/COMPOUND % by WT % Element 108-88-3 Toluene 12 100-41-4 Ethylbenzene 2 1330-20-7 Xylene 13 CALIFORNIA PROPOSITION 65 WARNING: This product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. TSCA CERTIFICATION All chemicals in this product are listed, or are exempt from listing, on the TSCA Inventory. SECTION 16-OTHER INFORMATION This product has been classified in accordance with the hazard criteria of the Canadian Controlled Products Regulations (CPR) and the MSDS contains all of the information required by the CPR. The above information pertains to this product as currently formulated, and is based on the information available at this time. Addition of reducers or other additives to this product may substantially alter the composition and hazards of the product. Since conditions of use are outside our control, we make no warranties, express or implied, and assume no liability in connection with any use of this information.
The information contained in this MSDS was obtained from current and reliable sources, however, the data is provided without any warrenty, expressed or implied, regarding its correctness or accuracy. Since the conditions or handling, storage and disposal of this product are beyond the control of Imperial Supplies LLC, Imperial will not be responsible for loss, injury, or expense arising out of the products improper use. No warranty, expressed or inferred, regarding the product described in this 'MSDS' shall be created or inferred by any statement in this 'MSDS'. Various government agencies may have specific regulations regarding the transportation, handling, storage, use, or disposal of this product which may not be covered by this 'MSDS'. The user is responsible for full compliance.