Product Categories See All
Track Order Status
MSDS Sheet 0065970Printer Friendly View
IMPERIAL SUPPLIES LLC MSDS SHEET FOR 6597 & 6597-1 The Blaster Corporation MSDS Number: CC- aerosol Revision Date: 03/24/09 Section 1. Product and Company Information: Product Name: Contact Cleaner. Revision Date: 03/24/09 MSDS Number: CC-aerosol. Product Code: 16-CC Manufacturer: The Blaster Corporation 8500 Sweet Valley View, Ohio 44125 (216) 901-5800 (216) 901-5801 fax www.blasterproducts.com 24 Hour Emergency: Chemtrec (800) 424-9300 Section 2. Composition/Information on Ingredients: Hazardous CAS # Percent Exposure Limits: Ingredients: n-Propyl bromide 106-94-5 >90 % See Section 15 Carbon Dioxide 124-38-9 <3 % OSHA (TWA) 5000 ppm ACGIH (TWA) 5000 ppm Section 3. Hazardous Identification: Route Of Entry: Eyes, skin, inhalation, ingestion. Target Organs: Inhalation: May Irritate the nose throat, and lungs. Exposure to high doses may cause central nervous system depression. Such doses may also cause adverse effect in liver, kidney and lung. Skin Contact: May cause irritation. Eye Contact: May cause irritation. Ingestion: Low toxicity, not expected to be a hazard at normal use. May aggravate a pre existing condition. Physical Hazard: Aerosol containers are pressurized (even when empty!) Do not expose to temperatures above 120 F. Do not puncture or burn can. Failure to observe these precautions may result in rapid and violent decompression of the container producing projectiles and atomization of the liquid contents. Notice: Reports have associated repeated and prolonged occupational overexposure to solvents with permanent brain and nervous system damage. Intentional misuse by deliberately concentrating and inhaling the contents may be harmful or fatal. Section 4. First Aid Measures: Inhalation: Remove to fresh air. If not breathing, give artificial respiration. If breathing is difficult, give oxygen. Continue to monitor. Get medical attention. Skin Contact: Remove contaminated clothing immediately! Wash skin with soap and water. If irritation persists, seek medical attention. Eye Contact: Flush eye(s) with water for 15 minutes. If irritation persists, seek medical treatment. Ingestion: Do no induce vomiting. Seek medical attention. Section 5. Fire Fighting Measurers: Flashpoint: None. Autoignition Temperature: ~490 C Flammable/Explosion Limits: 3.8-9.50% by volume in air. Extinguishing Media: Dry Chemical. Carbon dioxide, alcohol foam or polymer foam (Class ABC, BC fire extinguisher.) Water may not be effective. Unusual Fire and Explosion Hazard: Level 3 Aerosols- Contents Under Pressure. Section 6. Accidental Release Measures: Leaking aerosol cans should be put into suitable container until the internal pressure has dissipated. Use suitable absorbents to collect liquid product. Consult regulations for the disposal of the container, liquid and absorbents. Section 7. Handling and Storage: Handling Precautions: Use in accordance with good industrial workplace practices. Avoid unnecessary contact. Wash thoroughly after handling. Use with good ventilation. Storage Requirements: Store in a dry place away from excessive heat. Store containers with lids on and properly labeled. Do not store at temperatures above 120 degrees F. Section 8. Physical and Chemical Properties: Appearance: Clear Colorless Physical State: Liquid. Odor: Strong alcohol-like pH: Not Determined. Vapor Pressure: ~110.8 mm Hg @ 20 C Vapor Density: >1 (air=1) Boiling Point: 158 F Freezing/Melting Pt.: Not Determined. Solubility: Negligible. Spec Grav./Density: 1.31-1.32 Heat Value: Not Determined. VOC: Not Determined. Evap. Rate: 6.0 (nBuOAc=1.0) Bulk Density: Not Determined. Octanol: Not Determined. Molecular Weight: Not Determined. Particle Size: Not Applicable. Softening Point: Not Applicable. Viscosity: Not Determined. Percent Volatile: 100 Sat. Vap. Concentrat: Not Determined. Molecular Formula: Not Determined. Section 10 Stability and Reactivity: Stability: This product is stable under normal conditions. Conditions to Avoid: Storage temperature above 120 F Materials to Avoid (incompatibility): Avoid strong mineral acids and strong oxidizing agents. Prolonged contact with aluminum, magnesium and zinc metals should be avoided. Hazardous Decomposition Products: Hydrogen bromide, carbon monoxide and carbon dioxide. Hazardous Polymerization: Will not occur. Section 11. Toxicological Information: N, Propyl bromide LD50 Rat, oral - 4260 mg/kg LC50 Rat, inhalation - 25300 mg/m3/0.5 hr Section 12. Ecological Information: No information available. Section 13. Disposal Considerations: Used or unused product should be disposed of in accordance with local, state and federal regulations. Some special regulations may exist for the disposal of aerosol containers. Empty containers may contain residual pressure and contents. They should be handled with the same precautions as the product. Section 14. Transport Information: Department of Transportation (DOT): This product, as it leaves Blaster's facilities, meets the definitions set forth in CFR 49 part 173.150c as a "consumer commodity." Allowing for certain exceptions (173.156) for domestic surface (ground) shipments. Proper Shipping Name: Consumer Commodity. Hazard Class: ORM-D International (IMDT-IATA): Proper Shipping Name: Aerosols, Limited Quantity. Hazard Class: 2 Non-Flammable Compressed Gas. UN Number: 1950 Section 15. Regulatory Information: The following is a selected list of regulatory requirements. Not all such requirements are identified. Users of this product are solely responsible for compliance with all applicable federal, state and local regulations. This product contains n-propyl bromide a substance listed in California's Safe Drinking Water and Toxic Enforcement Act of 1986- Proposition 65. Right To Know, NJ & PA. Occupational exposure limits for Toxicology Excellence for Risk n-propyl bromide: Assessment reports 20ppm ICF Consulting Group Reports 25ppm Environmental Protection Agency reports 25ppm ACGIH reports 10ppm Supplier's TWA 25ppm All components of this product are listed on the TSCA inventory. Section 16. Other Information: Manufacturer's Disclaimer: To the best of our knowledge, the information contained herein is accurate. However, neither The Blaster Chemical Companies nor any of its subsidiaries assumes any liability whatsoever for the accuracy or completeness of the information contained herein. Final determination of suitability of any material is the sole responsibility of the user. All materials may present unknown hazards and should be used with caution. Although certain hazards described herein, we cannot guarantee that these are the only hazards which exist. HMIS Ratings: Health: 1 Fire: 0 Reactivity: 0
The information contained in this MSDS was obtained from current and reliable sources, however, the data is provided without any warrenty, expressed or implied, regarding its correctness or accuracy. Since the conditions or handling, storage and disposal of this product are beyond the control of Imperial Supplies LLC, Imperial will not be responsible for loss, injury, or expense arising out of the products improper use. No warranty, expressed or inferred, regarding the product described in this 'MSDS' shall be created or inferred by any statement in this 'MSDS'. Various government agencies may have specific regulations regarding the transportation, handling, storage, use, or disposal of this product which may not be covered by this 'MSDS'. The user is responsible for full compliance.