Product Categories See All
Track Order Status
Sheet 0065480Printer Friendly View
MATERIAL SAFETY DATA SHEET Date Prepared; 12/1/1998 MSDS No; DSR - Aerosol Decal Sticker Remover - part #'s 16-DSR Imperial Part # 6548 & 6548-1 1. CHEMICAL PRODUCT AND COMPANY IDENTIFICATION MANUFACTURER; 24 HR. EMERGENCY TELEPHONE The Blaster Chemical Companies NUMBERS; Blaster Emergency Contact CHEMTREC 8500 Sweet Valley Drive Emergency Phone (800) 424-9300 Valley View, Oh 44125 Customer Service; (800) 858-6605 DISTIBUTOR: Imperial Supplies LLC 789 Packer Dr Green Bay, WI 54307 800-558-2808 Emergency Contact - Chem Tel Phone Number - 800-255-3924 2. COMPOSITION/INFORMATION ON INGREDIENTS Wt.% Cas Registy # D-Limonene <40 5989-27-5 1-Propoxy-2-Propanol <50 1569-01-3 Carbon Dioxide <2 124-38-9 COMMENTS; The criteria for listing components in this section are as follows; Carcinogens are listed if present at 0.1% or greater OSHA hazardous ingredients are listed if present at 1.0% or greater Non-Hazardous ingredients may be listed if present at 5.0% or greater 3. HAZARDS IDENTIFICATION POTENTIAL HEALTH EFFECTS EYES; Likely to cause immediate or delayed irritation. Irritation will show as redness and/or swelling of the eyes. SKIN; Repeated or prolonged contact with skin may produce irritation, dryness, or dermatitis. INGESTION; Ingestion may cause irritation to the mouth, esophagus, and stomach. INHALATION; Inhalation of vapors or mist may irritate respiratory tract. Inhalation of excessive amounts may cause central nervous system effects such as dizziness, nausea, &/or headaches. PHYSICAL HAZARDS; Aerosol containers are pressurized (even when empty!) Do not expose to temperatures above 120 degrees Fahrenheit. Do not puncture or burn can. Failure to observe these precautions may result in a rapid and violent decompression of the container producing projectiles and atomization of the liquid contents. COMMENTS; NOTICE - Reports have associated repeated and prolonged occupational overexposure to solvents with permanent brain and nervous system damage. Intentional misuse by deliberately concentrating and inhaling the contents may be harmful or fatal. 4. FIRST AID MEASURES EYES; Flush with plenty of clear water. Seek medical attention. SKIN; Remove contaminated clothing immediately. Wash skin with soap and water. If irritation develops, seek medical attention. INGESTION; If swallowed, do NOT induce vomiting. Give victim a glass of water or milk. Call a physician or poison control center immediately. Never give anything by mouth to an unconscious person. INHALATION; Remove to fresh air. Seek medical attention. 5. FIRE FIGHTING MEASURES Flashpoint and Method; 119 F TAG CC GENERAL HAZARD; This material can be ignited by heat, sparks, flames, or other sources of ignition (static electricity.) Vapors are heavier than air and will collect in low areas (sewers) or travel considerable distances to a source of ignition. If containers are not cooled in a fire, they may ignite and explode. EXTINGUISHING MEDIA; Dry chemical, carbon dioxide, halon, or foam is recommended. Water spray may be used to cool containers or structures.Halon may decompose into toxic materials and carbon dioxide will displace oxygen. Take proper precautions when using these materials. HAZARDOUS COMBUSTION PRODUCTS; Thermal decomposition in the presence of air may yield, carbon monoxide, carbon dioxide, and various hydrocarbons. FIRE FIGHTING PROCEDURES; Emergency responders in the danger area should wear bunker gear and self-contained breathing apparatus for fires beyond the incipient stage.Wear other protective gear as conditions warrant. Stop leaks, if it can be done with minimal risk. Water spray may be useful in dispersing vapors or cooling equipment and containers.Material will float on water. Avoid spreading fire with water. 6. ACCIDENTAL RELEASE MEASURES SMALL SPILL; Absorb the liquid and scrub the area with detergent and water. LARGE SPILL; After eliminated source of release, absorb free liquid with suitable absorbent. Avoid allowing liquid into sewers or water ways. Dispose of absorbents and liquid in accordance with local, state, and federal laws. 7. HANDLING AND STORAGE HANDLING; Avoid contact. Wash thoroughly after handling. STORAGE; Store containers sealed and upright when not in use. Rotate stock. Store away from excessive heat. 8. EXPOSURE CONTROLS/PERSONAL PROTECTION PERSONAL PROTECTION EYES AND FACE; Standard safety glasses with splash shields are adequate protection. Where excessive splashing is possible, a face sheild should be used. SKIN; Excessive contact should be avoided. Neoprene gloves and aprons will provide adequate protection when contact cannot be avoided. RESPIRATORY; Good general ventilation should be sufficient to control airborne levels. Maintain airborne concentrations below the established exposure limits of ingredients in Section 2. PROTECTIVE CLOTHING; Chemical resistant aprons and boots are suggested when contact with material cannot be avoided. Remove and wash any contaminated clothing immediately. WORK HYGIENIC PRACTICES; Wash thoroughly after handling. OTHER USE PRECAUTIONS; Eye wash stations and emergency showers should be available. COMMENTS; The BLASTER CHEMICAL COMPANIES takes no responsibility for determining what measures are required for personal protection in any specific application. The information provided should be used with discretion. 9. PHYSICAL AND CHEMICAL PROPERTIES Physical state; Liquid Odor; Heavy Citrus Odor. Appearance; Transparent Color; Clear Percent Volatile; 95 Boiling Point; 347 F Solubility in Water; Completely Miscible Specific Gravity; 0.8578 10. STABILITY AND REACTIVITY Stable; Yes Hazardous Polymerization; No Conditions to Avoid; Avoid high temperatures. Stability; Stable Polymerization; Will not occur 11. TOXICOLOGICAL INFORMATION COMMENTS Toxicological information on this product as a mixture has yet to be determined. see Section 15 for reportable ingredients. 12. ECOLOGICAL INFORMATION ENVIRONMENTAL DATA; No data available. Contact Env. Dept. ECOTOXICOLOGICAL INFORMATION; No data available. Contact Env. Dept. 13. DISPOSAL CONSIDERATIONS DISPOSAL METHOD; Used or unused product should be disposed of in accordance with local, state, and federal regulations. EMPTY CONTAINER; Empty containers will contain residual product and should be handled in the same manner as the product. Containers should be returned to a reputable container reconditioner. 14. TRANSPORT INFORMATION DOT (DEPARTMENT OF TRANSPORTATION) Proper Shipping Name; Consumer Commodity Hazard Class; ORM-D NA/UN Number; 1950 Packing Group; lll NAERG; 126 Other Shipping Information; This product, as it leaves Blaster's facilities, meets the definitions set forth in CFR 49 part 173. 150c as a "consumer commodity." Allowing for certain exceptions(173.156) for domestic surface shipments. 15. REGULATORY INFORMATION UNITED STATES SARA TITLE lll (SUPERFUND AMENDMENTS AND REAUTHORIZATION ACT) Title lll Notes; There are no SARA 313 reportable materials in this product. CERCLA (COMPREHENSIVE RESPONSE, COMPENSATION, AND LIABILITY ACT) CERCLA RQ; This product has no CERCLA Reportable Quantity. However, release into a waterway may require reporting to the National Response Center. TSCA (TOXIC SUBSTANCE CONTROL ACT) TSCA Regulatory; This product complies with all TSCA Inventory requirements. 16. OTHER INFORMATION Approval date; 03/05/2001 REVISION SUMMARY Revision #; 3 This MSDS replaces the March 05, 2001 MSDS. Any changes in information are as follows; In Section 1 MSDS Number In Section 3 Physical Hazards (text) In Section 14 Proper shipping Name Technical Name DOT Hazard Class UN/NA Number other DOT Shipping Information (text) Dot Emergency Response Guide HMIS CODES Fire; 2 Health; 1 Reactivity; 0 Protection; C MANUFACTURER DISCLAIMER; To the best of our knowledge, the information contained herein is accurate. However, neither The Blaster Chemical Companies nor any of its subsidiaries assumes any liability whatsoever for the accuracy or completeness of the information contained herein. Final determination of suitability of any material is the sole responsibility of the user. All materials may present unknown hazards and should be used with caution. Although certain hazards are described herein, we cannot guarantee that these are the only hazards which exists.
The information contained in this was obtained from current and reliable sources, however, the data is provided without any warrenty, expressed or implied, regarding its correctness or accuracy. Since the conditions or handling, storage and disposal of this product are beyond the control of Imperial Supplies LLC, Imperial will not be responsible for loss, injury, or expense arising out of the products improper use. No warranty, expressed or inferred, regarding the product described in this '' shall be created or inferred by any statement in this ''. Various government agencies may have specific regulations regarding the transportation, handling, storage, use, or disposal of this product which may not be covered by this ''. The user is responsible for full compliance.