MSDS 9521

                            MATERIAL SAFETY DATA SHEET


NOTE; BLANK SPACES ARE NOT PERMITTED. IF ANY ITEM IS NOT APPLICABLE, THE SPACE
MUST BE MARKED TO INDICATE THAT.

IDENTITY                                                    PART NO.
(As shown on Label or package)   LIQUID TAPE (F-825)   IF APPLICABLE
                                                             29980073
Imperial Part # - 9521 & 9527

                                    SECTION 1


MANUFACTURER'S                                 EMERGENCY PHONE NO.
NAME      Plasti Dip International Inc.         USA only: 1-800-424-9300
                                                INT'L: 703-527-3887
ADDRESS (NUMBER, STREET, CITY, STATE AND ZIP CODE)
3920 Pheasant Ridge Drive
Blaine, MN  55449 

                                 MANUFACTURER'S PHONE
                                 No. FOR INFORMATION
                                 1-763-785-2156

DATE MSDS WAS PREPARED  January 20,2004
REVISION #  0002

                 SECTION II - HAZARDOUS INGREDIENTS INFORMATION.


All Health Hazards which comprise 1% or greater of the composition and all
carcinogens if 0.1% of the composition or greater.

Hazardous Components    % Wt.     CAS NO.     OSHA      ACGIH     Other Limits
Chemical And Identity                         PEL       TLV       Recommend
And Common Name(S)
(Optional)
--------------------------------------------------------------------------------
VM & P Naphtha          33.5-35.0 64742-89-8  300 ppm   300 ppm   None
Heptane                 14.5-15.0 426260-76-6 500 ppm   400 ppm   None
Xylene                  12.5-13.0 1330-20-7   100 ppm   100 ppm   None
Methyl Ethyl Ketone     7.7 - 8.3 78-93-3     200 ppm   200 ppm   None
Ethylbenzene            3.0 - 3.2 100-41-4    100 ppm   100 ppm   None


                SECTION III -  PHYSICAL / CHEMICAL CHARACTERISTICS


BOILING  175 -285ºF.     SPECIFIC GRAVITY (H20=1)   APPROXIMATE WEIGHT
POINT                                               PER GALLON  (LBS)
          79-141ºC          0.83                         6.87

VAPOR PRESSURE      VAPOR DENSITY                EVAPORATION RATE
78 mmHg @ 20ºC      (Air=1) Heavier than air   (Butyl Acetate=1) > 1.0

SOLUBILITY IN WATER         % VOLATILE 71-74.5%         OTHER
Insoluble                     VOC LBS/GAL  4.4-4.5       (IF ANY) None

APPEARANCE
AND ODOR  Various Colors, Honey Like Substance - Characteristic Odor


                   SECTION IV - FIRE AND EXPLOSION HAZARD DATA


FLASH POINT  20.0ºF  (-7ºC)   FLAMMABLE LIMITS      LEL    UEL
(METHOD USED)   TCC                                 0.9    11.5

EXTINGUISHING
MEDIA   Carbon Dioxide, Dry Chemical, or Foam

SPECIAL
FIRE FIGHTING PROCEDURES
Self contained breathing apparatus with a full face piece, operated in pressure
demand or other positive pressure mode.

UNUSUAL FIRE AND
EXPLOSION HAZARDS
This material is flammable and may be ignited by heat, sparks, flame or static
electricity.

HAZARDOUS PRODUCTS FORMED BY
FIRE OR THERMAL DECOMPOSITION
Carbon Dioxide and/or Carbon Monoxide.

EXPLOSIVE LIMITS
(% BY VOLUME IN AIR)  0.9 - 11.5


               SECTION V -  OPTIONAL HAZARD RATINGS IDENTIFICATION


HAZARD RATING
4-EXTREME
3-HIGH
2-MODERATE
1-SLIGHT
0-INSIGNIFICANT
**SEE SECTION IV

National Fire Protection Association (NFPA)

FIRE     3      REACTIVITY       0
HEALTH   2      SPECIAL HAZARDS  None


                   SECTION VI -  REACTIVITY AND STABILITY DATA


STABILITY         UNSTABLE     STABLE X     CONDITIONS TO AVOID  None

INCOMPATIBILITY (Materials to Avoid)  Strong acids, bases, oxidizing agents,
selected amines with alkali metals and halogens.

HAZARDOUS DECOMPOSITION OR BY PRODUCTS
Carbon Monoxide, Carbon Dioxide.

HAZARDOUS      MAY OCCUR      CONDITIONS TO AVOID
POLYMERIZATION      WILL NOT OCCUR  X      None


                        SECTION VII -  HEALTH HAZARD DATA


ROUTES OF ENTRY: INHALATION? Yes SKIN? Yes INGESTION? Yes  EYES? Yes
HEALTH   ACUTE    X      See signs and Symptoms of Exposure below.
HAZARD   CHRONIC  X      Brain and Nervous System Damage (Referred to
                           As solvents or painter syndrome). Drying or Cracking
CARCINOGENICITY:      IARC 2B

SIGNS AND
SYMPTOMS OF   Headache, Dizziness, Drowsiness, Fatigue, Irregular Heartbeat,
EXPOSURE      Skin and Eye Irritation.
               Target Organs: CNS, CVS, PNS, Liver, Kidneys, Lungs,
                              Respiratory System, Skin.

MEDICAL CONDITIONS GENERALLY AGGRAVATED BY EXPOSURE
Pre-existing Heart, Liver, Kidney and Lung disorders.

EMERGENCY AND   Ingestion: Contact Physician or Poison Control Immediately.
FIRST AID      Inhalation: Remove to fresh air. Administer Oxygen or
                           Artificial Respiration if Necessary.
PROCEDURES   Eye Contact: Flush with large amounts of water. If irritation
                            persists, contact Physician.
               Skin: Wash with soap and water.


              SECTION VIII -  PRECAUTIONS FOR SAFE HANDLING AND USE


STEPS TO BE TAKEN   IN CASE MATERIAL IS
RELEASED OR SPILLED:
         Wipe up with floor absorbent. Transfer to hood. Prevent run-off to sewe
      Eliminate all sources of ignition. Ventilate to maintain
      Exposure below PEL's. Use sand or other material to
        dam or contain spills. If large spill, notify appropriate
         state and local agencies.

WASTE DISPOSAL METHODS  Dispose of product in accordance with local, county,
            state and federal regulations.

PRECAUTIONS TO BE   Keep away from sparks, flame and heat sources. Do not
            store above 120ºF and use adequate ventilation.

TAKEN IN HANDLING   Avoid inhalation of vapors and contact with liquid product.
AND STORAGE      Use good personal hygiene.

OTHER         Keep container Closed When Not In Use. Containers
PRECAUTIONS      Should be disposed of in an environmentally safe
            manner in accordance with governmental Regulations.


                          SECTION IX -  CONTROL MEASURES


RESPIRATORY PROTECTION (SPECIFY TYPE)   Depending on the Airborne
                     concentration, use a Respirator
                     with appropriate NIOSH approved
                     cartridge or supplied air equipment.

PROTECTIVE GLOVES  Impervious Gloves

VENTILATION   LOCAL EXHAUST Supplemental (if needed)
         MECHANICAL (GENERAL) To maintain exposure below PEL's
         SPECIAL   None
         OTHER      None

EYE PROTECTION
Chemical splash goggles, or approved eye protection

OTHER PROTECTIVE CLOTHING OR EQUIPMENT
Chemical Apron/Eye bath/Safety Shower

WORK HYGIENIC PRACTICES Wash thoroughly after handling.


               SECTION X -  TRANSPORTATION INFORMATION  (Optional)


DOT PROPER SHIPPING NAME  Coating Solution
DOT HAZARD CLASS  3
DOT UN NUMBER  UN1139
DOT PACKING GROUP II
IATA PROPER SHIPPING NAME  Coating Solution
IATA HAZARD CLASS  3
IATA UN NUMBER UN  1139
IATA PACKING GROUP  II


                     SECTION  XI  - 313 SUPPLIER NOTIFICATION


THIS PRODUCT CONTAINS THE FOLLOWING CHEMICALS SUBJECT TO REPORTING REQUIREMENTS
OF SECTION 313 OF THE EMERGENCY PLANNING AND COMMUNITY RIGHT-TO-KNOW ACT OF
1986, 40 CFR 372,
(see table on page 1 for CAS # and percent by weight).
Xylene, Methyl Ethyl Ketone, and Ethyl Benzene

WARNING; THIS PRODUCT CONTAINS A CHEMICAL KNOWN TO THE STATE OF CALIFORNIA TO
CAUSE CANCER AND BIRTH DEFECTS. OR OTHER REPRODUCTIVE HARM.

Prepared By: Andrew Stooksbury

The information provided herein is based on data considered accurate. No
warranty is expressed or implied regarding the accuracy of the data or the
results obtained from its use. Since the information contained herein may be
applied under conditions beyond the vendors control and since subsequent data
may suggest modification of the information. Vendor assumes no responsibility
for the results of its use.

The information contained in this MSDS was obtained from current and reliable sources, however, the data is provided without any warrenty, expressed or implied, regarding its correctness or accuracy. Since the conditions or handling, storage and disposal of this product are beyond the control of Imperial Supplies LLC, Imperial will not be responsible for loss, injury, or expense arising out of the products improper use. No warranty, expressed or inferred, regarding the product described in this MSDS shall be created or inferred by any statement in this MSDS. Various government agencies may have specific regulations regarding the transportation, handling, storage, use, or disposal of this product which may not be covered by this MSDS. The user is responsible for full compliance.

© 2008 Imperial Supplies LLC Questions or comments? Contact us.