LOGIN
Login E-mail:
Password:

Apply for an account! »
Product Search
Bottom
 

MSDS 9133

9133: All Purpose Spray Adhesive [12]
9133-1: All Purpose Spray Adhesive [6]
MSDS Last updated: 08/28/2008

Permatex, Inc.
10 Columbus Blvd.
Hartford, CT 06106  USA
Telephone: 1-87-Permatex
(877) 376-2839
Emergency: 800-255-3924
International Emergency: 813-248-0585

                 MATERIAL SAFETY DATA SHEET

1. PRODUCT IDENTIFICATION
Product Name:  118DA ALL PURPOSE SPRAY ADHESIVE 10.5 OZ AE
Item No:       82019
Product Type:  Aerosol adhesive


2. COMPOSITION/INFORMATION ON INGREDIENTS
Component                     Weight %       ACGIH: TLV-TWA       OSHA PEL:


Petroleum Gases, Liquefied      30-60          Not Listed         Not Listed
Sweetened
68476-86-8


Acetone                         10-30          500 ppm:          1000 ppm TWA:
67-64-1                                        1188 mg/m3       2400 mg/m3 TWA


N-Hexane                        10-30          50 ppm             500 ppm TWA:
110-54-3                                                         1800 mg/m3 TWA


Cyclohexane                      < 5           300 ppm:           300 ppm TWA:
110-82-7                                      1030 mg/m3        1050 mg/m3 TWA


3. HAZARDS IDENTIFICATION

Toxicity:     May cause nervous system depression. Intentional misuse
              by concentrating and inhaling the vapor may be harmful or fatal. 
              Long term exposure to high concentrations of vapor may cause      
              lung, liver or kidney damage. High concentrations may cause       
             central nervous system (CNS) depression. Reports have associated   
            repeated and prolonged overexposure to solvents with permanent      
           brain and nervous system damage (sometimes referred to as
              "solvent" or "painter's syndrome"). Symptoms include fatigue,
              concentration difficulties, anxiety, depression, rapid mood      
              swings, and short-term memory loss.  Aspiration hazard if         
             swallowed. May cause eye, skin and respiratory irritation.         
           N-Hexane may damage peripheral nerve tissue.
Primary Routes of Entry: Eye and skin contact, ingestion, inhalation.
Signs and Symptoms of Exposure:  Excessive overexposure may cause giddiness,
              dizziness, headache, nausea and in extreme cases, unconsciousness
              and respiratory depression. Overexposure may cause eye and skin  
              redness, difficulty breathing and vomiting. Swallowing: This      
            material can enter the lungs during swallowing or vomiting and      
            cause lung inflammation and/or damage. Aspiration into the lungs    
           can cause chemical pneumonia which can be fatal.

Component       Weight%         NTP             ACGIH                 IARC
                                              Carcinogens
Acetone          10-30        Not known     A4 - Not Classifiable   Not known
67-64-1                                        as a Human
                                               Carcinogen


Medical Conditions Recognized as      Person with preexisting respiratory,      
Bing Aggravated by Exposure:          liver, kidney, eye or skin diseases may 
                                      be adversely affected.


4. FIRST AID MEASURES
Ingestion:     Do not induce vomiting. Slowly dilute with 1-2 glasses of
               water or milk and seek medical attention. Never give anything by 
              mouth to an unconscious person.
Inhalation:    Move to fresh air in case of accidental inhalation of
               vapors. Oxygen or artificial respiration if needed. Obtain       
        medical attention.
Skin Contact:  Wash off immediately with soap and plenty of water removing
               all contaminated clothes and shoes. If skin irritation persists, 
              call a physician.
Eye Contact:   In case of contact, immediately flush eyes with plenty of
               water for at least 15 minutes and get medical attention if       
        irritation persists.


5. FIRE FIGHTING MEASURES
Flash Point (F degrees/C):        Extremely flammable aerosol per flame
                                  projection test
Recommended Extinguishing Media:  Carbon Dioxide, Dry Chemicals, Foam.
Special Fire-Fighting Procedures: Firefighters should wear self-contained
                                  breathing apparatus.
                                  Keep containers cool. Use equipment or        
                          shielding required to protect against or              
                    venting of containers. Water spray may be
                                  ineffective on flames but should be used to   
                               keep fire-exposed containers cool.
Hazardous Products of Combustion: Carbon Monoxide and Carbon Dioxide.
Unusual Fire/Explosion Hazards:   Contents under pressure Exposure to
                                  temperatures over 120 degrees F. may cause    
                              bursting or venting. Use equipment or             
                     shielding to protect personnel from bursting               
                   containers.


   Lower Explosive Limit:    Not determined
   Upper Explosive Limit:    Not determined


6. ACCIDENTAL RELEASE MEASURES
Spill Procedures:   Eliminate all sources of ignition. Maintain good
                    ventilation.  Take up with an inert absorbent. Store in a   
                 closed waste container until disposal.


7. HANDLING AND STORAGE
Storage:       Store away from heat, sparks or open flame. Do not store at
               temperatures above 120 degrees. F. Exposure to high temperatures 
              may cause container to burst. Store in accordance with NFPA 30B   
            for Level 3 Aerosols.
Handling:      Avoid contact with skin and eyes. Wash thoroughly with
               soap and water after handling. Use only in a well ventilated     
          area. Intentionally concentrating and inhaling the vapor may be       
        harmful or fatal. Do not use near heat, sparks or open flame.           
    Extinguish all flames, pilot lights and heaters.
               Turn off stoves, electric tools and appliances, and other
               sources of ignition. Vapors may accumulate readily and may 
               ignite explosively. Do not puncture or incinerate container.


8. EXPOSURE CONTROLS/PERSONAL PROTECTION
Eyes:            Safety glasses.
Skin:            Neoprene or nitrile gloves recommended.
Ventilation:     General: local exhaust ventilation as necessary to
                 control any air contaminants to within their exposure limits   
              (or to the lowest feasible levels when limits have not been       
          established) during the use of this product.
Respiratory Protection: An approved organic vapor respirator should be worn
                 when exposures are expected to exceed the applicable limits.

9. PHYSICAL AND CHEMICAL PROPERTIES
Appearance:               White liquid
Odor:                     SOLVENT ODOR
Boiling Point:            >100 degrees F
Ph:                       Does not apply
Solubility in Water:      Nil
Specific Gravity:         0.6-0.7
VOC Content(Wt.%):        64.9 % by weight
Vapor Pressure;           Not determined
Vapor Density (Air=1):    Heavier than air
Evaporation Rate:         >1 (butyl acetate = 1)


10. STABILITY AND REACTIVITY
Chemical Stability:               Stable at normal conditions
Hazardous Polymerization:         Will not occur.
Incompatibilities:                Strong oxidizers, Acids
Conditions to Avoid:              Keep away from heat, sparks and open flame
Hazardous Products of Combustion: Carbon Monoxide and Carbon Dioxide.


11. TOXICOLOGICAL INFORMATION
See Section 3


12. ECOLOGICAL INFORMATION
No data available


13. DISPOSAL CONSIDERATIONS
Recommended Method of Disposal:  Disposal should be made in accordance with
federal, state and local regulations. This container may be recycled in
aerosol recycling centers. Before offering for
recycling, empty the can by using the product according to the label. If
recycling is not available, wrap the container and discard in the trash.
US EPA Waste Number:      D001 as per 40CFR 261.21


14. TRANSPORTATION INFORMATION
DOT  (49CFR 172)
Domestic Ground Transport
      DOT Shipping Name:     Consumer Commodity (not more than one liter)
      Hazard Class:          ORM-D
      UN/ID Number:          None
      Marine Pollutant:      None


   IATA
      Proper Shipping Name:  Consumer Commodity (Not more than 1 liter)
      Class or Division:     Class 9
      UN/ID Number:          ID 8000


   IMDG
      Proper Shipping:       Aerosols, Limited Quantity
      Hazard Class:          Class 2.1
      UN Number:             UN 1950


15. REGULATORY INFORMATION
SARA 313 Chemicals:  The following component(s) is listed as a SARA Section
313 Toxic Chemial.

N-HEXANE, CYCLOHEXANE

CALIFORNIA PROP 65:
WARNING: This product contains chemicals known to the State of California to
cause cancer and birth defects or other reproductive harm.

TSCA Inventory Status:
Listed on Inventory:  YES All components of this product are listed (or
exempt) on the EPA TSCA Inventory.


16. OTHER INFORMATION
Estimated NFPA Rating:           Health 2, Flammability 4, Reactivity 0
Estimated HMIS Classification:   Health 2, Flammability 4, Physical Hazard 0
NFPA is a registered trademark of the National Fire Protection Assn.
HMIS is a registered trademark of the National Paint and Coatings Assn.


Prepared By:   Denise Boyd, Manager-Environmental, Health & Safety
               Revision Date:      April/29/2008
Company:       Permatex, Inc. 10 Columbus Blvd. Hartford, CT USA 06106
               Revision       2
               Number:
Telephone No:  1-87-Permatex  (877) 376-2839

The information contained in this MSDS was obtained from current and reliable sources, however, the data is provided without any warrenty, expressed or implied, regarding its correctness or accuracy. Since the conditions or handling, storage and disposal of this product are beyond the control of Imperial Supplies LLC, Imperial will not be responsible for loss, injury, or expense arising out of the products improper use. No warranty, expressed or inferred, regarding the product described in this MSDS shall be created or inferred by any statement in this MSDS. Various government agencies may have specific regulations regarding the transportation, handling, storage, use, or disposal of this product which may not be covered by this MSDS. The user is responsible for full compliance.

For more product information by email, click here

Imperial Supplies LLC does not provide services and products outside the United States

credit card logos