![]() |
![]() |
![]() |
|
| Home > Products > Chemicals & Paint > MSDS Sheets > MSDS 9130 -- [Back] | |||
|
MSDS 9130 9130: Thread Sealant W/Teflon 16 Oz. [1]MSDS Last updated: 10/13/2006
Permatex, Inc.
10 Columbus Blvd.
Hartford, CT 06106 USA
Telephone: 1-87-Permatex
(877) 376-2839
Emergency: 800-255-3924
International Emergency: 813-248-0585
MATERIAL SAFETY DATA SHEET
1. PRODUCT IDENTIFICATION
--------------------------------------------------------------------------------
Product Name: 14D THREAD SEALANT WITH TEFLON 1PT
Item: 80633
Product Type: Sealant
2. COMPOSITION/INFORMATION ON INGREDIENTS
--------------------------------------------------------------------------------
Ingredient Weight Percent ACGIH TLV: OSHA PEL:
2-Propanol 35-45 200 ppm TWA 400 ppm TWA:
67-63-0 980 mg/m3 TWA:
Talc 20-30 2 mg/m3 respir. 20 mppcf TWA
14807-96-6 dust TWA
Castor Oil 20-30 Not Listed Not Listed
8001-79-4
Polyvinyl Resin 1-10 Not Listed Not Listed
63148-65-2
Titanium Dioxide 1-10 10 mg/m3 15 mg/m3 TWA
13463-67-7 TWA ACGIH (total dust)
Polytetrafluoroethylene 1-10 Not Listed Not Listed
9002-84-0
3. HAZARDS IDENTIFICATION
--------------------------------------------------------------------------------
Toxicity: May cause eye, skin and respiratory irritation.
Primary Routes of Entry: Eye and skin contact, ingestion, inhalation.
Signs and Symptoms of Exposure: Excessive accidental exposure may cause
headache, dizziness, nausea and mild respiratory irritation. Overexposure may
cause eye and skin redness.
Ingredient Weight NTP ACGIH IARC
Percent Carcinogens
2-Propanol 35-45 A-4 Not classifiable Group 3
67-63-0 as a human Monograph 71,
Carcinogen 1999, Supp. 7,
1987.
Monograph 15,1977
Talc 20-30 male rat A-4 Not classifiable Group 3
14807-96-6 some evidence as a human Supplement 7,
Female rat-clear Carcinogen 1987
Evidence, male Monograph 42
Mice-no evidence, 1987
Female mice-no
Evidence.
Titanium Dioxide 1-10 Male rat-negative, A4 Group 3: Vol 47,
13463-67-7 female rat-negative pg 307, 1989
Male mice-negative,
Female mice-negative
Polytetrafluoroethylene
9002-84-0 1-10 Group 3
Supplement 7,1987
Monograph 19, 1979
Medical Conditions Recognized as Preexisting eye, skin and respiratory
Aggravated by Exposure: disorders may be aggravated by over
exposure to this product.
4. FIRST AID MEASURES
--------------------------------------------------------------------------------
Ingestion: Do not induce vomiting. Slowly dilute with 1-2 glasses of water or
milk and seek medical attention. Never give anything by mouth to an
unconscious person.
Inhalation: Move to fresh air in case of accidental inhalation of vapors.
Oxygen or artificial respiration if needed. Obtain medical attention.
Skin Contact: Wash off with soap and water. If skin irritation persists, call a
physician.
Eye Contact: In case of contact, immediately flush eyes with plenty of water
for at least 15 minutes and get medical attention if irritation persists.
5. FIRE FIGHTING MEASURES
--------------------------------------------------------------------------------
Flash Point (F/C): 74 degrees F. Method: Tag Closed Cup
Recommended Extinguishing Media; Carbon Dioxide, Dry Chemicals, Foam.
Special Fire-Fighting Procedures: Firefighter should wear self contained
breathing apparatus.
Water spray may be ineffective on flames but should be used to keep
fire-exposed containers cool.
Hazardous Products of Combustion: Oxides of carbon, Fluoride compounds.
Unusual Fire/Explosion Hazards: Closed containers may rupture or explode when
exposed to extreme heat.
Lower Explosive Limit: 2.3
Upper Explosive Limit: 12.7
6. ACCIDENTAL RELEASE MEASURES
--------------------------------------------------------------------------------
Spill Procedures: Eliminate all sources of ignition. Maintain good ventilation.
Take up with an inert absorbent. Store in a closed waste container
until disposal. Residues may be cleaned up with isopropyl alcohol.
7. HANDLING AND STORAGE
--------------------------------------------------------------------------------
Storage: Store away from heat, sparks or open flame. Do not store at
temperatures above 120 degrees F.
Handling: Avoid contact with skin and eyes. Do not inhale vapors.
Keep container closed when not in use.
8. EXPOSURE CONTROLS/PERSONAL PROTECTION
--------------------------------------------------------------------------------
Eyes: Safety glasses
Skin: Rubber or plastic gloves
Ventilation: General: local exhaust ventilation as necessary to control any air
contaminants to within their exposure limits (or to the lowest
feasible levels when limits have not been established) during the
use of this product.
Respiratory Protection: An approved respirator (i.e. NIOSH, etc.) should be worn
when exposures are expected to exceed the applicable limits.
9. PHYSICAL AND CHEMICAL PROPERTIES
Appearance: White paste
Odor: Alcoholic
Boiling Point: 180 degrees F.
pH: Does not apply
Solubility in Water: Partial
Specific Gravity: 1.12
VOC Content(Wt.%): 37.9% by weight
Vapor Pressure: 33 mm Hg @ 68 degrees F.
Vapor Density (Air=1): 2.07
Evaporation Rate: 7.7 (ether = 1)
10. STABILITY AND REACTIVITY
--------------------------------------------------------------------------------
Chemical Stability: Stable at normal conditions
Hazardous Polymerization: WILL NOT OCCUR.
Incompatibilities: Strong oxidizers
Conditions to Avoid: Keep away from heat, sparks, and open flame. -
No smoking
Hazardous Products of Combustion: Oxides of carbon, Fluoride compounds
11. TOXICOLOGICAL INFORMATION
--------------------------------------------------------------------------------
See Section 3
12. ECOLOGICAL INFORMATION
--------------------------------------------------------------------------------
No data available
13. DISPOSAL CONSIDERATIONS
--------------------------------------------------------------------------------
Recommended Method of Disposal: Disposal should be made in accordance with
federal, state and local regulations.
US EPA Waste Number: D001 as per 40 CFR 261.21
14. TRANSPORTATION INFORMATION
--------------------------------------------------------------------------------
DOT (49CFR 172)
Domestic Ground Transport
DOT Shipping Name: Consumer Commodity (Not more than five liters)
Hazard Class: ORM-D
UN/ID Number: None
Marine Pollutant: None
IATA
Proper Shipping Name; Consumer Commodity (Not more than 1 liter)
Class or Division: Class 9
UN/NA Number: ID 8000
IMDG
Proper Shipping: Adhesives containing flammable liquid, Limited Quantity
Hazard Class: Class 3 PGIII
UN Number: UN 1133
15. REGULATORY INFORMATION
--------------------------------------------------------------------------------
SARA 313 Chemicals: The following component(s) is listed as a SARA Section 313
Toxic Chemical.
NONE
CALIFORNIA PROP 65:
No California Prop 65 chemicals are known to be present.
TSCA Inventory Status:
Listed on Inventory: YES All components of this product are listed (or exempt)
on the EPA TSCA inventory.
16. OTHER INFORMATION
--------------------------------------------------------------------------------
Estimated NFPA Rating: Health 2, Flammability 3, Reactivity 0
Estimated HMIS Classification: Health 2, Flammability 3, Physical Hazard 0
NFPA is a registered trademark of the National Fire Protection Assn.
HMIS is a registered trademark of the National Paint and Coatings Assn.
Prepared By: Denise Boyd, Health and Safety Manager Revision Date: 09/27/2006
Company: Permatex. Inc. 10 Columbus Blvd. Hartford, CT USA 06106 Revision 3
Number:
The information contained in this MSDS was obtained from current and reliable sources, however, the data is provided without any warrenty, expressed or implied, regarding its correctness or accuracy. Since the conditions or handling, storage and disposal of this product are beyond the control of Imperial Supplies LLC, Imperial will not be responsible for loss, injury, or expense arising out of the products improper use. No warranty, expressed or inferred, regarding the product described in this MSDS shall be created or inferred by any statement in this MSDS. Various government agencies may have specific regulations regarding the transportation, handling, storage, use, or disposal of this product which may not be covered by this MSDS. The user is responsible for full compliance. For more product information by email, click here Imperial Supplies LLC does not provide services and products outside the United States |