Start an Order |
|
|
|
| Start an Order |
|||
| Home > Products > Chemicals & Paint > MSDS Sheets > MSDS 9129 -- [Back] | |||
|
MSDS 9129 9129: Thread Sealant W/Teflon 4 Oz [2]MSDS Last updated: 04/15/2008
Permatex, Inc.
10 Columbus Blvd.
Hartford, CT 06106 USA
Telephone: 1-87-Permatex
(877) 376-2839
Emergency: 800-255-3924
International Emergency: 813-248-0585
MATERIAL SAFETY DATA SHEET
1. PRODUCT IDENTIFICATION
Product Name: 14H THREAD SEALANT W/PTFE 4 FL.OZ.
Item No: 80632
Product Type: Sealant
2. COMPOSITION/INFORMATION ON INGREDIENTS
Component Weight% ACGIH TLV: TWA OSHA PEL:
Ethanol 20-40 1000 ppm: 1000 ppm TWA:
64-17-5 STEL 1000 ppm 1900 mg/m3 TWA
Talc 20-40 2 mg/m3 respir. 20 mppcf TWA
14807-96-6 dust TWA
Castor Oil 20-40 Not Listed Not Listed
8001-79-4
Polyvinyl Resin 5-20 Not Listed Not
Listed63148-65-2
2-Propanol <5 200 ppm TWA 400 ppm TWA:
67-63-0 980 mg/m3 TWA
Titanium Dioxide <3 10 mg/m3 15 mg/m3 TWA
13463-67-7 TWA ACGIH (total dust)
Methanol <3 200 ppm TWA: 200 ppm TWA:
67-56-1 262 mg/m3 TWA 260 mg/m3 TWA
Polytetrafluoroethylene <3 Not Listed Not Listed
9002-84-0
3. HAZARDS IDENTIFICATION
Toxicity: May cause eye, skin and respiratory irritation. Methanol
may cause blindness or death if swallowed.
Primary Routes of Entry: Eye and skin contact, ingestion, inhalation.
Signs and Symptoms of Exposure: Excessive accidental exposure may cause
headache, dizziness, nausea and mild respiratory irritation.
Overexposure may cause eye and skin redness.
Component Weight% NTP ACGIH IARC
Carcinogens
Ethanol 20-40 A4- Not Classifiable Group 1
64-17-5 as a Human (drinking alcohol)
Carcinogen Vol. 44, pg 35,
1988
Talc 20-40 male rat- A4- Not classifiable Group 3
14807-96-6 some evidence, as a human Supplement 7,
Female rat- carcinogen 1987
Clear evidence, Monograph
Male mice-no 42, 1987
Evidence,
Female mice-no
Evidence
2-Propanol <5 A4- Not classifiable Group 3
67-63-0 as a human Monograph 71,
Carcinogen 1999: supp. 7,
1987
Monograph
15, 1977
Titanium Dioxide <3 male rat- A4 Group 2B: Vol 93
13463-67-7 negative 2006: Vol 47,
Female rat- 1989
Negative, male
Mice- negative
Female mice-
Negative
Polytetraflyoroethylene <3 Group 3
9002-84-0 Supplement 7,
1987:
Monograph 19, 1979
Medical Conditions Recognized as Preexisting eye, skin and respiratory
Being Aggravated by Exposures: disorders may be aggravated by
overexposure to this product.
4. FIRST AID MEASURES
Ingestion: Do not induce vomiting. Slowly dilute with 1-2
glasses of water or milk and seek medical attention.
Never give anything by mouth to an unconscious person.
Inhalation: Move to fresh air in case of accidental inhalation
of vapors.
Oxygen or artificial respiration if needed.
Obtain medical attention.
Skin Contact: Wash off with soap and water. If skin irritation
persists. Call a physician.
Eye Contact: In case of contact, immediately flush eyes with plenty of
water for at least 15 minutes and get medical attention
if irritation persists.
5. FIRE FIGHTING MEASURES
Flash Point (F/C degrees): 74 degrees F TCC
Recommended Extinguishing Media: Carbon Dioxide, Dry Chemicals, Foam
Special Fire-Fighting Procedures: Firefighters should wear self-
contained breathing apparatus. Water spray
may be ineffective on flames but should be
used to keep fire-exposed containers cool.
Hazardous Products of Combustion: Oxides of carbon. Fluoride compounds
Unusual Fire/Explosion Hazards: Closed containers may rupture or explode
when exposed to extreme heat.
Lower Explosive Limit: 2.3
Upper Explosive Limit: 12.7
6. ACCIDENTAL RELEASE MEASURES
Spill Procedures: Eliminate all sources of ignition. Maintain good
ventilation. Take up with an inert absorbent.
Store in a closed waste container until disposal.
Residues may be cleaned up with isopropyl alcohol.
7. HANDLING AND STORAGE
Storage: Store away from heat, sparks or open flame. Do not store
at temperatures above 120 degrees F.
Handling: Avoid contact with skin and eyes. Do not inhale
vapors. Keep container closed when not in use.
8. EXPOSURE CONTROLS/PERSONAL PROTECTION
Eyes: Safety glasses
Skin: Rubber or plastic gloves.
Ventilation: General: local exhaust ventilation as necessary to
control any air contaminants to within their exposure limits
(or to the lowest feasible levels when limits have not been
established) during the use of this product.
Respiratory Protection: An approved respirator (i.e. NIOSH) should be worn
when exposures are expected to exceed the applicable limits.
9. PHYSICAL AND CHEMICAL PROPERTIES
Appearance: White paste
Odor: Alcoholic
Boiling Point: 180 degrees F
pH: Does not apply
Solubility in Water: Partial
Specific Gravity: 1.06-1.10
VOC Content(Wt.%): 36.5%
Vapor Pressure: 33 mm Hg @ 68 degrees F.
Vapor Density (Air=1): 2.07
Evaporation Rate: 7.7 (ether = 1)
10. STABILITY AND REACTIVITY
Chemical Stability: Stable at normal conditions
Hazardous Polymerization: WILL NOT OCCUR
Incompatibilities: Strong oxidizers
Conditions to Avoid: Keep away from heat, sparks and open flame.
-No smoking -
Hazardous Products of Combustion: Oxides of carbon, Fluoride compounds
11. TOXICOLOGICAL INFORMATION
See Section 3
12. ECOLOGICAL INFORMATION
No data available
13. DISPOSAL CONSIDERATIONS
Recommended Method of Disposal: Disposal should be made in accordance with
federal, state and local regulations.
US EPA Waste Number: D001 as per 40CFR 261.21
14. TRANSPORTATION INFORMATION
DOT (49CFR 172)
Domestic Ground Transport
DOT Shipping Name: Consumer Commodity (Not more than five liters)
Hazard Class: ORM-D
UN/ID Number: None
Marine Pollutant: None
IATA
Proper Shipping Name: Consumer Commodity (Not more than 1 liter)
Class or Division: Class 9
UN/NA Number: ID 8000
IMDG
Proper Shipping: Adhesives containing flammable liquid, Limited Quantity
Hazard Class: Class 3 PGIII
UN Number: UN 1133
15. REGULATORY INFORMATION
SARA 313 Chemicals: The following component(s) is listed as a SARA Section
313 Toxic Chemical.
Methanol
CALIFORNIA PROP 65:
No California Prop 65 chemicals are known to be present.
TSCA Inventory Status:
Listed on Inventory: YES All components of this product are listed (or
exempt) on the EPA TSCA inventory.
16. OTHER INFORMATION
Estimated NFPA Rating: Health 2, Flammability 3, Reactivity 0
Estimated HMIS Classification: Health 2, Flammability 3, Physical Hazard 0
NFPA is a registered trademark of the National Fire Protection Assn.
HMIS is a registered trademark of the National Paint and Coatings Assn.
Prepared By: Denise Boyd, Health and Safety Manager
Revision Date: October/23/2007
Company: Permatex, Inc. 10 Columbus Blvd. Hartford, CT USA 06106
Revision 1
Number:
The information contained in this MSDS was obtained from current and reliable sources, however, the data is provided without any warrenty, expressed or implied, regarding its correctness or accuracy. Since the conditions or handling, storage and disposal of this product are beyond the control of Imperial Supplies LLC, Imperial will not be responsible for loss, injury, or expense arising out of the products improper use. No warranty, expressed or inferred, regarding the product described in this MSDS shall be created or inferred by any statement in this MSDS. Various government agencies may have specific regulations regarding the transportation, handling, storage, use, or disposal of this product which may not be covered by this MSDS. The user is responsible for full compliance. For more product information by email, click here Imperial Supplies LLC does not provide services and products outside the United States |
Printer-Friendly View
