![]() |
![]() |
![]() |
|
| Home > Products > Chemicals & Paint > MSDS Sheets > MSDS 9110 -- [Back] | |||
|
MSDS 9110 9110: Disc Brake Caliper Lube 8 Oz [1]9110-4: Disc Brake Caliper Lube 8 Oz [6] MSDS Last updated: 10/22/2008
Permatex, Inc.
10 Columbus Blvd.
Hartford, CT 06106 USA
Telephone: 1-87-Permatex
(877) 376-2839
Emergency: 800-255-3924
International Emergency: 813-248-0585
Material Safety Data Sheet
1. PRODUCT IDENTIFICATION
Product Name: ULTRA DISC BRAKE CALIPER LUBE 8 FL.OZ
Item No: 24110
Product Type: Lubricant
2. COMPOSITION/INFORMATION ON INGREDIENTS
Component Weight% ACGIH; TLV-TWA OSHA PEL:
SYNTHETIC BASE OILS >90 Not listed Not listed
TRADE SECRET
3. HAZARDS IDENTIFICATION
Toxicity: May cause eye and skin irritation.
Primary Routes of Entry: Eye and skin contact, ingestion, inhalation
Signs and Symptoms of Exposure: Overexposure may cause eye and skin redness.
Medical Conditions Recognized as Preexisting skin disorders.
Being Aggravated by Exposure:
4. FIRST AID MEASURES
Ingestion: If swallowed, DO NOT induce vomiting. Keep individual calm.
Obtain medical attention.
Inhalation: Move to fresh air in case of accidental inhalation of
vapours. If signs of irritation or toxicity occur seek
medical attention.
Skin Contact: Remove contaminated clothing. Wash area with soap and water.
If irritation persists, seek medical attention.
Eye Contact: In case of contact, immediately flush eyes with plenty of
water for at least 15 minutes and get medical attention if
irritation persists.
5. FIRE FIGHTING MEASURES
Flash Point °F(C°): >500 degrees F COC
Recommended Extinguishing Media: Carbon Dioxide, Dry Chemicals, Foam.
Special Fire-Fighting Procedures: Treat as oil fire. Firefighters should wear
self-contained breathing apparatus.
Hazardous Products of Combustion: Oxides of carbon
Unusual Fire/Explosion Hazards: None
Lower Explosive Limit: Not determined.
Upper Explosive Limit: Not determined.
6. ACCIDENTAL RELEASE MEASURES
Spill Procedures: Maintain good ventilation. Take up with an inert
absorbent. Store in a closed waste container until
disposal.
7. HANDLING AND STORAGE
Storage: Store away from heat.
Handling: Avoid contact with skin and eyes. Wash thoroughly
after handling. Product may cause surfaces to
become slippery.
8. EXPOSURE CONTROLS/PERSONAL PROTECTION
Eyes: Safety glasses.
Skin: Neoprene or nitrile gloves recommended.
Ventilation: General ventilation is usually adequate.
Respiratory Protection: Not normally necessary.
9. PHYSICAL AND CHEMICAL PROPERTIES
Appearance: Green semi-solid
Odor: MILD
Boiling Point: Not determined.
pH: Does not apply
Solubility in Water: Insoluble
Specific Gravity: 0.89
VOC Content(Wt.%): None
Vapor Pressure: Not Determined
Vapor Density (Air=1): > 1 (air = 1)
Evaporation Rate: <1 (butyl acetate = 1)
10. STABILITY AND REACTIVITY
Chemical Stability: Stable at normal conditions
Hazardous Polymerization: WILL NOT OCCUR.
Incompatabilities: Strong oxidizers
Conditions to Avoid: Welding
Hazardous Products of Combustion: Oxides of carbon
11. TOXICOLOGICAL INFORMATION
See Section 3
12. ECOLOGICAL INFORMATION
No data available
13. DISPOSAL CONSIDERATIONS
Recommended Method of Disposal: Disposal should be made in accordance with
federal, state and local regulations.
US EPA Waste Number: NH - Not a RCRA Hazardous Waste Material
14. TRANSPORTATION INFORMATION
DOT (49CFR 172)
Domestic Ground Transport
DOT Shipping Name: Unrestricted
Hazard Class: None
UN/ID Number: None
Marine Pollutant: None
IATA
Proper Shipping Name: Unrestricted
Class or Division: None
UN/ID Number: None
IMDG
Proper Shipping: Unrestricted
Hazard Class: None
UN Number: None
15. REGULATORY INFORMATION
SARA 313 Chemicals: The following component(s) is listed as a SARA Section 313
Toxic Chemical.
NONE
CALIFORNIA PROP 65:
No California Prop 65 chemicals are known to be present.
TSCA Inventory Status:
Listed on Inventory: YES All components of this product are listed (or exempt)
on the EPA TSCA inventory.
16. OTHER INFORMATION
Estimated NFPA Rating: HEALTH 1, FLAMMABILITY 1, INSTABILITY 1 .
Estimated HMIS Classification: HEALTH 1, FLAMMABILITY 1, PHYSICAL HAZARD 0
NFPA is a registered trademark of the National Fire Protection Assn.
HMIS is a registered trademark of the National Paint and Coatings Assn.
Prepared By: Denise Boyd, Manager-Environmental, Health & Safety
Revision Date: May/27/2008
Company: Permatex. Inc. 10 Columbus Blvd. Hartford, CT USA 06106
Revision 1
Number:
Telephone No: 1-87-Permatex (877) 376-2839
3 of 3
The information contained in this MSDS was obtained from current and reliable sources, however, the data is provided without any warrenty, expressed or implied, regarding its correctness or accuracy. Since the conditions or handling, storage and disposal of this product are beyond the control of Imperial Supplies LLC, Imperial will not be responsible for loss, injury, or expense arising out of the products improper use. No warranty, expressed or inferred, regarding the product described in this MSDS shall be created or inferred by any statement in this MSDS. Various government agencies may have specific regulations regarding the transportation, handling, storage, use, or disposal of this product which may not be covered by this MSDS. The user is responsible for full compliance. For more product information by email, click here Imperial Supplies LLC does not provide services and products outside the United States |