MSDS 9103

Permatex, Inc.
10 Columbus Blvd.
Hartford, CT 06106  USA
Telephone: 1-87-Permatex
(877) 376-2839
Emergency: 800-255-3924
International Emergency: 813-248-0585

                 MATERIAL SAFETY DATA SHEET

1. PRODUCT IDENTIFICATION
Product Name:    HIGH STRENGTH THREAD LOCKER RED 6ML
Item No:         27100
Product Type:    Anaerobic

2. COMPOSITION/INFORMATION ON INGREDIENTS
Component                   Weight%         ACGIH TLV: TWA       OSHA PEL:
Polyglycol Dimethacrylate    60-80           Not Listed          Not Listed
25852-47-5

Polyester Resin              20-40           Not Listed          Not Listed
Mixture

Dimethyl Benzyl               <3             Not Listed          Not Listed
Hydro Peroxide
80-15-9

Saccharin                   0.5-2.0          10 mg/m3            Not Listed
81-07-2                                    nuisance dust

3. HAZARDS IDENTIFICATION
Toxicity:        At elevated temperatures may cause irritation of the
                 respiratory tract. Irritates mucous membranes.
                 Ingestion may irritate digestive tract and cause nausea,
                 vomiting and diarrhea. High concentrations may cause
                 central nervous system (CNS) depression. May cause
                 eye and skin irritation. May cause skin sensitization.
                 Note: This product does not contain microcrystalline
                 silica.
Primary Routes of Entry:  Eye and skin contact, ingestion, inhalation.
Signs and Symptoms of Exposure:  Repeated skin contact may cause allergic
                 skin reactions. Skin redness. Ingestion may cause
                 nausea and vomiting. Inhalation overexposure may
                 cause irritation, coughing and flu-like symptoms.
                 May cause pain, redness or swelling of the eyes and
                 excessive blinking and tear production.

Component         Weight %       NTP                   ACGIH         IARC
                                                     Carcinogens
Saccharin         0.5-2.0      Delisted April 2000                   Group 3:
81-07-2                                                              Vol 73.
                                                                     Page 517:
                                                                     1999

Medical Conditions Recognized as        Preexisting skin disorders.
Being Aggravated by Exposure:

4. FIRST AID MEASURES
Ingestion:       If swallowed, DO NOT induce vomiting.
                 Keep individual calm. Obtain medical attention.
Inhalation:      Move to fresh air in case of accidental inhalation
                 of vapors. Obtain medical attention.
Skin Contact:    Wash off with soap and water. If skin irritation
                 persists, call a physician.
Eye Contact:     In case of contact, immediately flush eyes with plenty
                 of water for at least 15 minutes and get medical
                 attention if irritation persists.

5. FIRE FIGHTING MEASURES
Flash Point (F/C): >200 degrees C
Recommended Extinguishing Media: Dry chemical, Carbon dioxide, foam.
Special Fire-Fighting Procedures: Firefighters should wear self-contained
                 breathing apparatus. Water spray may be ineffective on
                 flames but should be used to keep fire-exposed
                 containers cool.
Hazardous Products of Combustion: Oxides of carbon
Unusual Fire/Explosion Hazards:   Closed containers may rupture or explode
                 when exposed to extreme heat. May polymerize
                 exothermically.

Lower Explosive Limit: Not determined
Upper Explosive Limit: Not determined

6.  ACCIDENTAL RELEASE MEASURES
Spill Procedures: Maintain good ventilation. Take up with an inert
                  absorbent. Store in a closed waste container
                  until disposal.

7. HANDLING AND STORAGE
Storage:         Store away from heat. Store away from water or
                 moisture. Protect from contamination.
                 Keep containers tightly closed in a cool, well-
                 ventilated place.
Handling:        Avoid prolonged skin contact. Keep away from eyes.

8. EXPOSURE CONTROLS/PERSONAL PROTECTION
Eyes:            Safety glasses.
Skin:            Rubber or plastic gloves.
Ventilation:     General: local exhaust ventilation as necessary to
                 control any air contaminants to within their
                 exposure limits (or to the lowest feasible levels
                 when limits have not been established) during the
                 use of this product.
Respiratory Protection:  An approved respirator (i.e.NIOSH etc.) should be
                 worn when exposures are expected to exceed the
                 applicable limits.

9. PHYSICAL AND CHEMICAL PROPERTIES
Appearance:             Red liquid
Odor:                   MILD
Boiling Point:          >150 degrees C
pH:                     Does not apply
Solubility in Water:    Insoluble
Specific Gravity:       1.1
VOC Content (Wt.%):     <2% by weight
Vapor Pressure:         Not determined
Vapor Density (Air=1):  Heavier than air
Evaporation Rate :      Not Determined

10. STABILITY AND REACTIVITY
Chemical Stability:    Stable at normal conditions
Hazardous polymerization:  Will not occur.
Incompatibilities: Strong oxidizers, free radical initiators, inert gases.
                   Peroxides, Reducing agents. Oxygen scavengers.
Conditions to Avoid: Heat
Hazardous Products of Combustion:  Oxides of carbon.

11. TOXICOLOGICAL INFORMATION
See Section 3

12. ECOLOGICAL INFORMATION
No data available

13. DISPOSAL CONSIDERATIONS
Recommended Method of Disposal:  Disposal should be made in accordance with
federal, state and local regulations.
US EPA Waste Number:  NH - Not  a RCRA Hazardous waste Material

14. TRANSPORTATION INFORMATION
DOT  (49CFR 172)
Domestic Ground Transport
      DOT Shipping Name:     Unrestricted
      Hazard Class:          None
      UN/ID Number:          None
      Marine Pollutant:      None

IATA
      Proper Shipping Name:  Not regulated
      Class of Division:     None
      UN/NA Number:          None

IMDG
      Proper Shipping:       Unrestricted
      Hazard Class:          None
      UN Number:             None

15. REGULATORY INFORMATION
SARA 313 Chemicals: The following component(s) is listed as a SARA Section 313
Toxic Chemical.

DIMETHYL BENZYL HYDRO PEROXIDE

CALIFORNIA PROP 65:
No California Prop 65 chemicals are known to be present at or above the No
Significant Risk Level.

TSCA Inventory Status:
Listed on Inventory: YES All components of this product are listed (or exempt)
on the EPA TSCA inventory.

16. OTHER INFORMATION
Estimated NFPA Rating:          Health 2, Flammability 1, Reactivity 1
Estimated HMIS Classification:  Health 2, Flammability 1, Physical Hazard 0
NFPA is a registered trademark of the National Fire Protection Assn.
HMIS is a registered trademark of the National Paint and Coatings Assn.

Prepared By: Denise Boyd, Health and Safety Manager   Revision Date:
                                                      August/13/2007
Company; Permatex. Inc 10 Columbus Blvd. Hartford, CT USA 06106
                                                      Revision  1
                                                      Number:

The information contained in this MSDS was obtained from current and reliable sources, however, the data is provided without any warrenty, expressed or implied, regarding its correctness or accuracy. Since the conditions or handling, storage and disposal of this product are beyond the control of Imperial Supplies LLC, Imperial will not be responsible for loss, injury, or expense arising out of the products improper use. No warranty, expressed or inferred, regarding the product described in this MSDS shall be created or inferred by any statement in this MSDS. Various government agencies may have specific regulations regarding the transportation, handling, storage, use, or disposal of this product which may not be covered by this MSDS. The user is responsible for full compliance.

© 2008 Imperial Supplies LLC Questions or comments? Contact us.