MSDS 9100

Permatex, Inc.
10 Columbus Blvd.
Hartford, CT 06106 USA
Telephone: 1-87-Permatex
(877) 376-2839
Emergency: 800-255-3924
International Emergency: 813-248-0585

                       MATERIAL SAFETY DATA SHEET

1. PRODUCT IDENTIFICATION
Product Name:   MEDIUM STRENGTH THREAD LOCKER BLUE GEL
                10 GR
Item No:        24010
Product Type:   Anaerobic

2. COMPOSITION/INFORMATION ON INGREDIENTS
Ingredient               Weight Percent       ACGIH TLV:       OSHA PEL:
PolyGlycol                  35-45             Not Listed       Not Listed
Dimethacrylate
25852-47-5

Polyester Resin             15-25             Not Listed       Not Listed
Mixture

Benzoate Esters             15-25             Not Listed       Not Listed
Mixture

Treated Silicon Dioxide      1-10             10 mg/m3         10 mg/m3
Synthetic,                                 total dust TLV      total dust
Crystalline-Free
67762-90-7

Dimethyl benzyl               <3               Not Listed       Not Listed
Hydro peroxide
80-15-9

Propylene Glycol              <3              Not Listed        Not Listed
57-55-6

Polyamide Wax                 <3              Not Listed        Not Listed
Mixture

Titanium Dioxide            0.1-1.0            10 mg/m3         15 mg/m3
13463-67-7                                    TWA ACGIH          TWA
                                                               (total dust)

3. HAZARDS IDENTIFICATION
Toxicity:   May cause eye and skin irritation. At elevated temperatures
            may cause irritation of the respiratory tract. Irritates
            mucous membranes. Ingestion may irritate digestive tract
            and cause nausea, vomiting and diarrhea. High
            concentrations may cause central nervous system (CNS)
            depression. May cause skin sensitization. Note: This
            product does not contain microcrystalline silica.
Primary Routes of Entry:  Eye and skin contact, ingestion, inhalation.
Signs and Symptoms of Exposure: Repeated skin contact may cause
            allergic skin reactions. Skin redness. Ingestion may cause
            nausea and vomiting. Inhalation overexposure may cause
            irritation, coughing and flu-like symptoms. May cause
            pain, redness or swelling of the eyes and excessive
            blinking and tear production.

Ingredient            Weight          NTP        ACGIH             IARC
                      Percent                   Carcinogens

Titanium Dioxide      0.1-1.0       male rat-     A4             Group 2B:
13463-67-7                          negative                      Vol 93,
                                    female rat-                  2006: Vol
                                    negative,                    47, 1989
                                    male mice-
                                    negative,
                                    female mice-
                                    negative.

Medical Conditions Recognized as    Preexisting skin disorders.
Being Aggravated by Exposure:

4. FIRST AID MEASURES
Ingestion:  If swallowed, DO NOT induce vomiting. Keep
            individual calm. Obtain medical attention.
Inhalation: Move to fresh air in case of accidental inhalation
            of vapors. Obtain medical attention.
Skin Contact:  Wash off with soap and water. If skin irritation
            persists, call a physician.
Eye Contact: In case of contact, immediately flush eyes with
            plenty of water for at least 15 minutes and get
            medical attention if irritation persists.

5. FIRE FIGHTING MEASURES
Flash Point (F/C): More than 200 degrees C. Method: PMCC
Recommended Extinguishing Media:  Water fog, carbon dioxide,
            foam, dry chemical.
Special Fire-Fighting Procedures: Firefighters should wear self-
            contained breathing apparatus.
Hazardous Products of Combustion: Irritating vapors.
Unusual Fire/Explosion Hazards:   Closed containers may rupture
            or explode when exposed to extreme heat.

Lower Explosive Limit: Not determined
Upper Explosive Limit: Not determined

6. ACCIDENTAL RELEASE MEASURES
Spill Procedures: Maintain good ventilation. Take up with an
                 inert absorbent. Store in a closed container
                 until disposal.

7. HANDLING AND STORAGE
Storage:         Store below 100 degrees F.
Handling:        Avoid prolonged skin contact.
                 Keep away from eyes.

8. EXPOSURE CONTROLS/PERSONAL PROTECTION
Eyes:       Safety glasses.
Skin:       Rubber or plastic gloves.
Ventilation: General: local exhaust ventilation as necessary to
            control any air contaminants to within their
            exposure limits (or to the lowest feasible levels
            when limits have not been established) during the
            use of this product.
Respiratory Protection: An approved respirator (i.e. NIOSH, etc)
            should be worn when exposures are expected to
            exceed the applicable limits.

9. PHYSICAL AND CHEMICAL PROPERTIES
Appearance:            Blue gel
Odor:                  MILD
Boiling Point:         More than 150 degrees C.
pH:                    Does not apply
Solubility in Water:   Insoluble
Specific Gravity;      >1.0
VOC Content(Wt.%):     Not determined
Vapor Pressure:        Not determined
Vapor Density (Air=1): Heavier than air
Evaporation Rate:      Not Determined

10.  STABILITY AND REACTIVITY
Chemical Stability:       Stable at normal conditions.
Hazardous Polymerization: WILL NOT OCCUR.
Incompatibilities:        Strong oxidizers, free radical initiators,
                          inert gases.
Conditions to Avoid:      Heat
Hazardous Products of Combustion:  Irritating vapors

11. TOXICOLOGICAL INFORMATION
See Section 3

12. ECOLOGICAL INFORMATION
No data available

13. DISPOSAL CONSIDERATIONS
Recommended Method of Disposal: Disposal should be made in accordance with
federal, state and local regulations.
US EPA Waste Number:  NH - Not a RCRA Hazardous Waste Material

14. TRANSPORTATION INFORMATION
DOT  (49CFR 172)

Domestic Ground Transport
      DOT Shipping Name:     Unrestricted
      Hazard Class:          None
      UN/ID Number:          None
      Marine Pollutant:      None

IATA
      Proper Shipping Name:  Not regulated
      Class or Division:     None
      UN/NA Number:          None

IMDG
      Proper Shipping:       Unrestricted
      Hazard Class:          None
      UN Number;             None

15.  REGULATORY INFORMATION
SARA 313 Chemicals: The following component(s) is listed as a SARA
Section 313 Toxic Chemical.

DIMETHYL BENZYL HYDRO PEROXIDE

CALIFORNIA PROP 65:
No California Prop 65 chemicals are known to be present.

TSCA Inventory Status:
Listed on Inventory:  YES All components of this product are listed
                 (or exempt) on the EPA TSCA inventory.

16. OTHER INFORMATION
Estimated NFPA Rating:         Health 2, Flammability 1, Reactivity 1
Estimated HMIS Classification: Health 2, Flammability 1,
                               Physical Hazard 0
NFPA is a registered trademark of the National Fire Protection Assn.
HMIS is a registered trademark of the National Paint and Coatings Assn.

Prepared By: Denise Boyd, Health and Safety Manager  Revision Date:
                                                     12/13/2006
Company:  Permatex, Inc. 10 Columbus Blvd. Hartford, CT USA 06106
                                                     Revision  3
                                                     Number:

The information contained in this MSDS was obtained from current and reliable sources, however, the data is provided without any warrenty, expressed or implied, regarding its correctness or accuracy. Since the conditions or handling, storage and disposal of this product are beyond the control of Imperial Supplies LLC, Imperial will not be responsible for loss, injury, or expense arising out of the products improper use. No warranty, expressed or inferred, regarding the product described in this MSDS shall be created or inferred by any statement in this MSDS. Various government agencies may have specific regulations regarding the transportation, handling, storage, use, or disposal of this product which may not be covered by this MSDS. The user is responsible for full compliance.

© 2008 Imperial Supplies LLC Questions or comments? Contact us.