LOGIN
Login E-mail:
Password:

Apply for an account! »
Product Search
Bottom
 

MSDS 7549

7549: Dynacopper Silicone 3.35oz [6]
MSDS Last updated: 03/14/2005
                            MATERIAL SAFETY DATA SHEET
                                     DYNATEX®
                      350 RING ROAD  ELIZABETHTOWN, KY 42701
                    PH. (270) 769-5557     FAX; (270)769-6418


DYNACOPPER® RTV SILICONE GASKET MAKER
PART NO. 47101
 

                         SECTION 1 - IDENTITY INFORMATION

 
Product Identification:    DynaCopper RTV Silicone Gasket Maker
Chemical Family:           Moisture Curing Silicone Sealant
 

                        SECTION II - HAZARDOUS COMPONENTS

 
COMPONENT                CAS #       EXPOSURE LIMITS           WGT %
--------------------------------------------------------------------------------
Silica, Amorphous        112945-52-5 OSHA; TWA=6 mg/m3         3-6
                                     ACGIH: TWA=10 mg/m3
                                     Total Dust
Methyl Oximino Silane    22984-54-9  None Established          1-5
                                     See comments on Methyl
                                     Ethyl Ketoxime
Vinyl Oximino Silane     2224-33-1   None Established          0-3
                                     See comments on Methyl
                                     Ethyl Ketoxime
Limestone                1317-65-3   OSHA: TWA=10mg/m3         15-50
                                     ACGIH: TWA=10mg/m3
                                     Total Dust
 
Comments: Methyl Ethyl Ketoxime is formed upon contact with water or moisture in 
the air. Provide adequate ventilation to control exposures to within the 
exposure guideline of 2 ppm (TWA).
 

                           SECTION III - PHYSICAL DATA

 
Physical form:          Paste
pH:                     N/A
Viscosity;              N/A
Volatile Content;       N/A
Boiling Point;          N/A
Specific Gravity;       1.41
Solubility in Water:    Negligible
Vapor Pressure:         N/A
Vapor Density;          N/A
Melting Point:          N/A
Color;                  Copper
Odor:                   Slight
 

                   SECTION IV - FIRE AND EXPLOSION HAZARD DATA

 
Auto Ignition:             Not Determined
Flash Point:               Not Determined
Upper Explosive Limit (%): N/A
Lower Explosive Limit (%): N/A
Extinguishing Media:       Water, water fog (or spray). Carbon dioxide (C02).
                           Dry chemical. 
Special Fire Fighting Procedure:  
      Self-contained breathing apparatus and protective
      clothing. 
Unusual Fire and Explosion Hazards:     None
 

                          SECTION V- HEALTH HAZARD DATA

 
Eye Contact;     Direct contact irritates slightly with redness and
                 swelling. 
Skin Contact;    A single short exposure (less than 24 hours) may
                 irritate. Repeated prolonged contact (24 to 48 
                 hours) may irritate moderately. Product contains
                 oximes which are possible skin sensitizers. 
Inhalation:      Vapor overexposure may cause drowsiness, injure
                 blood, liver and may irritate eyes, nose and throat. 
Oral:            Small amounts transferred to the mouth by fingers
                 during use, etc. should not injure. Swallowing large
                 amounts may injure slightly. 
SPECIAL HEALTH EFFECTS:
            Carcinogens:           None Known.
            Teratogens;            None Known.
            Mutagens:              None Known.
            Reproductive Toxins:   None Known.
SENSITIZERS:
      22984-54-9     1-5%   Methyl Oximino Silane  Possible Skin Sensitizer
      2224-33-1      0-3%   Vinyl Oximino Silane   Possible Skin Sensitizer

Comments: Methyl Ethyl Ketoxime (MEKO) is formed upon contact with water or 
humid air. Male rodents exposed to MEKO vapor throughout their lifetime 
developed live tumors. Since many commonly used chemicals cause liver tumors in 
rats and mice, additional testing is planned by the MEKO supplier to determine 
any relevance to humans. Until more data is known, exposure levels should be 
maintained as low as achievable. 
 
FIRST AID PROCEDURES:
            Eye:   Immediately flush with water for 15 minutes. 
            Skin:  Remove from skin and immediately flush with
                   water for 15 minutes. Get medical attention if
                   irritation or ill effects develop or persist. 
            Inhalation;  Remove to fresh air. Get medical attention if ill
                         effects persist. 
            Oral:   Get medical attention.
Comments; Treat according to person's condition and specifics of exposure. 
 

                          SECTION VI -  REACTIVITY DATA

 
Stability:                Stable
Incompatibilities:        Oxidizing material can cause a reaction.
Hazardous Polymerization: Hazardous polymerization will not occur. 
Conditions to Avoid:      None
 

                   SECTION VII -  PERSONAL PROTECTIVE EQUIPMENT

 
Eye:     Use Proper protection - safety glasses as a minimum. 
Skin:    Wash at mealtime and end of shift. If skin
         contact occurs, change contaminated clothing 
         as soon as possible and thoroughly flush affected
         areas with cool water. Chemical protective gloves
         are recommended. 
Inhalation;   Use respiratory protection unless adequate local
              exhaust ventilation is provided or air sampling 
              data show exposures are within recommended
              exposure guidelines. 
Precautionary Measures:    Avoid eye contact. Avoid skin contact. Avoid
                           breathing vapor. 
 
Comments: Product evolves methyl ethyl ketoxime (MEKO) when exposed to water or
humid air. Provide ventilation during use to control methyl ethyl ketoxime 
(MEKO) within the exposure guidelines (Section II) or use respiratory 
protection. 
 

                     SECTION VIII - SPILL OR LEAK PROCEDURES

 
Spill or Leak Procedure;  Observe all personal protection equipment
                          recommendations described in Section VII.
Waste Disposal Methods:   Observe all applicable local, state and federal
                          waste management regulations. 
 

                  SECTION IX - HANDLING AND STORAGE PRECAUTIONS

 
Handling:        Observe precautions as indicated in section VI. 
Storage:         Keep container closed and store in a cool, well
                 ventilated area, away from water or moisture.
 

                      SECTION X - HAZARD COMMUNICATION CODES

 
NFPA RATINGS:
            Health;        1
            Flammability;  1
            Reactivity;    0
 

                        SECTION XI - SHIPPING INFORMATION

 
DOT Shipping Name:     None
DOT Hazard Class:      Non-hazardous
UN/NA Number;          N/A
Label Required:        None
 

                    SECTION XII - OTHER REGULATORY INFORMATION

 
TSCA;    All chemical substances found in this product comply
         with the Toxic Substances Control Act inventory
         reporting requirements. 
SARA 302:       No components subject to 40 CFR 370.
SARA 311 & 312; Not subject to reporting requirements of 40 CFR 370.
SARA 313;       No components subject to 40 CFR 372. 
 
 
 
The information contained herein is based on data considered accurate. However, 
no warranty is expressed or implied regarding the accuracy of the data or the 
results to be obtained from the use thereof. Because the information contained 
herein may be applied under conditions beyond our control, we assume no 
responsibility for its use.
 
Rev. 12/15/03

The information contained in this MSDS was obtained from current and reliable sources, however, the data is provided without any warrenty, expressed or implied, regarding its correctness or accuracy. Since the conditions or handling, storage and disposal of this product are beyond the control of Imperial Supplies LLC, Imperial will not be responsible for loss, injury, or expense arising out of the products improper use. No warranty, expressed or inferred, regarding the product described in this MSDS shall be created or inferred by any statement in this MSDS. Various government agencies may have specific regulations regarding the transportation, handling, storage, use, or disposal of this product which may not be covered by this MSDS. The user is responsible for full compliance.

For more product information by email, click here

Imperial Supplies LLC does not provide services and products outside the United States

credit card logos