MSDS 5593

                            Material Safety Data Sheet

May be used to comply with
OSHA's Hazard Communication Standard
29 CFR 1910.1200. Standard must be consulted
for specific requirements
 
U.S. Department of Labor
Occupational Safety and Health Administration
(Non-Mandatory Form)
Form Approved
OMB No. 1218-0072
 
IDENTITY (as used on Label and List)

SUPER LUBE NON-AEROSOL PUMP
Part Number - 51600
Imperial Part # 5593
 
Note: Blank spaces are not permitted. If any item is
not applicable, or no information is available, the
space must be marked to indicate that. 
 
                                    SECTION 1

 
Manufacturer's Name:  SYNCO CHEMICAL CORPORATION
Address:                24 DaVINCI  DRIVE
                         BOHEMIA, NY  11716
 
Emergency Telephone Number:  631-567-5300
Telephone Number for Information: 631-567-5300

Date Prepared:  January 1, 2003
Signature of Preparer (Optional):
 

             SECTION II - HAZARDOUS INGREDIENTS/IDENTITY INFORMATION

 
Hazardous Components             OSHA           ACGIH     Recommended   
                                   PEL          TLV       Percentages
(Specific Chemical/Identity: Common Name(s)
--------------------------------------------------------------------------------
SYNTHETIC HYDROCARBON            CAS# 68037-01-4            40-60%
HYDRO TREATED POLYMER            CAS# 8042-47-5            20-40%
AMINES,C11-14 BRANCHED ALKYL   CAS# 80939-62-4            .25-1.5%
POLYTETRAFLUORETHYLENE          CAS# 9002-84-0            1-3%
 
ALL INGREDIENTS ARE TSCA LISTED
 

                 SECTION III - PHYSICAL/CHEMICAL CHARACTERISTICS

 
Boiling Point               N/A      Specific Gravity (H20 = 1)    0.87 + 0.02

Vapor Pressure (mmHg.)   N/E      Melting Point                   N/A

Vapor Density (AIR = 1)   N/E      Evaporation Rate (Butyl Acetate =1)   N/E

Solubility in Water      Not Soluble in Water

Appearance and Odor      Translucent White to Slightly Yellow, Slight Odor
 

                   SECTION IV - FIRE AND EXPLOSION HAZARD DATA

 
Flash Point (Method used)    >428ºF (220ºC) COC   
Flammable Limits: N/A     LEL: N/E  UEL: N/E
 
Extinguishing Media: Carbon Dioxide, Dry Chemical, Foam
 
Special Fire Fighting Procedures: Self-contained respiratory protection should 
be provided for fighting fires in confined areas. 
 
Unusual Fire and Explosion Hazards:  None Known
 

                           SECTION V - REACTIVITY DATA

 
Stability:   Unstable
      Stable:  YES      Conditions to Avoid:   None Known
 
Incompatibility (materials to avoid):  N/E
 
Hazardous Decomposition or Byproducts: Burning may produce carbon monoxide.
 
Hazardous      May occur
Polymerization:   Will not occur: YES      Conditions to Avoid: None Known
 

                         SECTION VI - HEALTH HAZARD DATA

 
Route(s) of Entry:   INHALATION?   SKIN?  YES          INGESTION? YES
 
Health Hazards (Acute and Chronic):  No Evidence of adverse effect from 
available
information on swallowing.  SKIN ABSORPTION and INHALATION: May cause slight 
irritation in contact with skin and eyes. 
 
Carcinogenicity:   NTP?          IARC MONOGRAPHS?         OSHA REGULATIONS?
                     Not Listed  Not Listed             Not Listed
 
Signs and Symptoms of Exposure:  Contact with Eye may result in slight 
irritation. Prolonged or repeated skin contact may cause mild irritation.
 
Medical Conditions Generally Aggravated by Exposure:  N/E
 
Emergency and First Aid Procedures: SKIN: Remove by wiping and wash with soap 
and water.  EYES; Wash with copious amounts of water.
 

               SECTION VII - PRECAUTIONS FOR SAFE HANDLING AND USE

 
Steps to be Taken in Case Material is Released or Spilled: Spills should be 
absorbed or scraped up. 
 
Waste Disposal Method: Use method outlined in local EPA and Governmental 
Regulations. Contact your local EPA office. 
 
Precautions to be Taken in Handling and Storage: Good manufacturing practices 
should be followed in handling and storage. 
 
Other Precautions:  Surface subject to spills with this product can become 
slippery.

 
                         SECTION VIII -  CONTROL MEASURES

 
Respiratory Protection (Specify Type): None Required
 
Ventilation      Local Exhaust:         N/A         Special:   N/A
                 Mechanical (General)  N/A         Other;     N/A
 
Protective Gloves:    None under normal Use 
Eye Protection:    Safety Glasses Recommended
Other Protective Clothing or Equipment:  None under Normal Use
Work Hygienic Practices:  Normal Precautions common to good manufacturing 
practices should be followed. 
 
HMIS CODES:
 
FIRE:           1
HEALTH:        0
REACTANCE:   0
OTHER:        0
 
SLNAP:960627.4

The information contained in this MSDS was obtained from current and reliable sources, however, the data is provided without any warrenty, expressed or implied, regarding its correctness or accuracy. Since the conditions or handling, storage and disposal of this product are beyond the control of Imperial Supplies LLC, Imperial will not be responsible for loss, injury, or expense arising out of the products improper use. No warranty, expressed or inferred, regarding the product described in this MSDS shall be created or inferred by any statement in this MSDS. Various government agencies may have specific regulations regarding the transportation, handling, storage, use, or disposal of this product which may not be covered by this MSDS. The user is responsible for full compliance.

© 2008 Imperial Supplies LLC Questions or comments? Contact us.