Start an Order |
|
|
|
| Start an Order |
|||
| Home > Products > Chemicals & Paint > MSDS Sheets > MSDS 3511 -- [Back] | |||
|
MSDS 3511 3511: (DISCONTINUED)MSDS Last updated: 03/29/1999
MSDS SHEET FOR KWIK SEAL TUB & TILE #3511
*** SECTION 1 PRODUCT IDENTIFICATION ***
MANUFACTURER'S NAME: DAP INC.
MANUFACTURER'S ADDRESS: P.O. BOX 277
DAYTON, OH 45401-0277
EMERGENCY TELEPHONE: 1-800-535-5053 (TRANSPORTATION)
1-800-327-3874 (MEDICAL)
DISTRIBUTOR'S NAME: IMPERIAL SUPPLIES LLC
DISTRIBUTOR'S ADDRESS: 789 PACKER DRIVE
GREEN BAY, WI 54304
INFORMATION TELEPHONE: 1-800-558-2808
PRODUCT NAME: KWIK SEAL TUB & TILE ALM
PRODUCT NO.: 18013
IMPERIAL NO.: 3511
*** SECTION 2 HAZARDOUS INGREDIENTS ***
ITEM CHEMICAL NAME CAS # %
01 CALCIUM CARBONATE 1317-65-3 40-50
02 TITANIUM DIOXIDE 13463-67-7 1-5
03 PHTHALATE ESTERS PROPRIETARY 1-5
EXPOSURE LIMITS
ACGIH OSHA COMPANY
ITEM TLV-TWA TLV-STEL PEL-TWA PEL-CEILING TLV-TWA SKIN
O1 10 MG/M3 N.E. 15 MG/M3 N.E. N.E. NO
02 10 MG/M3 DUST N.E. 10 MG/M3 DUST N.E. 5 MG/M3 DUST NO
03 N.E. N.E. N.E. N.E. N.E. NO
*** SECTION 3 HAZARDS IDENTIFICATION ***
EMERGENCY OVERVIEW: CAUTION! MAY CAUSE EYE AND SKIN IRRITATION.
POTENTIAL HEALTH EFFECTS:
EFFECTS OF OVEREXPOSURE: EYE CONTACT: MAY CAUSE EYE IRRITATION.
EFFECTS OF OVEREXPOSURE: SKIN CONTACT: PROLONGED OR REPEATED CONTACT WITH
SKIN MAY CAUSE IRRITATION.
EFFECTS OF OVEREXPOSURE: INHALATION: VAPOR MAY CAUSE NOSE AND THROAT
IRRITATION.
EFFECTS OF OVEREXPOSURE: INGESTION: NONE KNOWN.
EFFECTS OF OVEREXPOSURE: CHRONIC HAZARDS: PROLONGED OR REPEATED CONTACT
WITH SKIN MAY CAUSE IRRITATION.
MEDICAL CONDITIONS WHICH MAY BE AGGRAVATED BY CONTACT: NONE KNOWN.
PRIMARY ROUTES OF ENTRY: SKIN AND EYE CONTACT
*** SECTION 4 FIRST AID MEASURES ***
EYE CONTACT: FLUSH WITH LARGE QUANTITIES OF WATER UNTIL IRRITATION SUBSIDES.
SKIN CONTACT: WASH WITH SOAP AND WATER.
INHALATION: REMOVE TO FRESH AIR.
INGESTION: DO NOT INDUCE VOMITING.
COMMENTS: CALL MEDICAL IN SECTION 1 IF IRRITATION OR COMPLICATIONS ARISE FROM
ANY OF THE ABOVE ROUTES OF ENTRY.
*** SECTION 5 FIRE FIGHTING MEASURES ***
FLASH POINT: >200 F SETAFLASH CLOSED CUP
LEL: N.A.
UEL: N.A.
AUTOIGNITION TEMPERATURE: N.A.
EXTINGUISHING MEDIA: CO2, DRY CHEMICAL, FOAM, WATER FOG
UNUSUAL FIRE AND EXPLOSION HAZARDS: NONE KNOWN.
SPECIAL FIREFIGHTING PROCEDURES: AS IN ANY FIRE, WEAR SELF-CONTAINED BREATHING
APPARATUS PRESSURE-DEMAND (MSHA/NIOSH APPROVED OR EQUIVALENT) AND
FULL PROTECTIVE GEAR. USE WATER SPRAY TO COOL EXPOSED SURFACES.
*** SECTION 6 ACCIDENTAL RELEASE MEASURES ***
SPILL OR LEAK PROCEDURES: USE ABSORBENT MATERIAL OR SCRAPE UP DRIED MATERIAL
AND PLACE INTO CONTAINERS.
*** SECTION 7 HANDLING & STORAGE ***
HANDLING INFORMATION: KEEP OUT OF REACH OF CHILDREN. AVOID PROLONGED OR
REPEATED CONTACT WITH SKIN. AVOID CONTACT WITH EYES.
STORAGE INFORMATION: STORE AWAY FROM CASUTICS AND OXIDIZERS. KEEP CONTAINERS
TIGHTLY CLOSED WHEN NOT IN USE. KEEP CONTAINERS FROM
EXCESSIVE HEAT AND FREEZING. DO NOT STORE AT TEMPERATURES
ABOVE 120 DEGREES F.
OTHER PRECAUTIONS: NONE.
*** SECTION 8 EXPOSURE CONTROLS/PERSONAL PROTECTION ***
ENGINEERING CONTROLS: NORMAL ROOM VENTILATION.
RESPIRATORY PROTECTION: A RESPIRATORY PROTECTION PROGRAM THAT MEETS OSHA
1910.134 AND ANSI Z88.2 REQUIREMENTS MUST BE FOLLOWED
WHENEVER WORKPLACE CONDITIONS WARRANT A RESPIRATOR'S
USE. NOT REQUIRED UNDER NORMAL USAGE AND ADEQUATE
VENTILATION.
EYE PROTECTION: SAFETY GLASSES WITH SIDE SHIELDS RECOMMENDED.
SKIN PROTECTION: NONE REQUIRED.
OTHER PROTECTIVE EQUIPMENT: NONE.
HYGIENIC PRACTICES: ALTHOUGH THIS PRODUCT IS NOT CONSIDERED AN EYE IRRITANT,
INHALATION HAZARD, OR A SKIN CONTACT HAZARD UNDER NORMAL
CONDITIONS, IT IS ADVISABLE THAT PERSONNEL MINIMIZESKIN
CONTACT, INHALATION OF VAPORS, AND EYE CONTACT. WASH
CONTAMINATED CLOTHING BEFORE REUSE.
*** SECTION 9 PHYSICAL & CHEMICAL PROPERTIES ***
BOILING RANGE: 210-220 F
ODOR: SLIGHT AMMONIA
APPEARANCE: COLORED PASTE
SOLUBILITY IN H20: NEGLIGIBLE
SPECIFIC GRAVITY: 1.5-1.6
VAPOR PRESSURE: 17 MM HG @ 68 F
PHYSICAL STATE: PASTE
VAPOR DENSITY: IS HEAVIER THAN AIR
EVAPORATION RATE: IS SLOWER THAN BUTYL ACETATE
*** SECTION 10 STABILITY & REACTIVITY ***
CONDITIONS TO AVOID: EXCESSIVE HEAT AND FREEZING.
INCOMPATIBILITY: STRONG OXIDIZERS AND CAUSTICS.
HAZARDOUS DECOMPOSITION PRODUCTS: NORMAL DECOMPOSITION PRODUCTS, I.E. COx, NOx
HAZARDOUS POLYMERIZATION: WILL NOT OCCUR UNDER NORMAL CONDITIONS.
STABILITY: THIS PRODUCT IS STABLE UNDER NORMAL STORAGE CONDITIONS.
*** SECTION 11 TOXICOLOGICAL PROPERTIES ***
NO PRODUCT OR COMPONENT TOXICOLOGICAL INFORMATION IS AVAILABLE.
*** SECTION 12 ECOLOGICAL INFORMATION ***
NO INFORMATION
*** SECTION 13 DISPOSAL CONSIDERATIONS ***
WASTE MANAGEMENT/DISPOSAL: DISPOSE OF ACCORDING TO FEDERAL, STATE, AND LOCAL
STANDARDS. THIS PRODUCT DOES NOT MEET THE DEFINITION OF A HAZARDOUS WASTE
ACCORDING TO U.S. EPA HAZARDOUS WASTE MANAGEMENT REGULATIONS, 40 CFR SECTION
261. STATE AND LOCAL REGULATIONS/RESTRICTIONS ARE COMPLESX AND MAY DIFFER
FROM FEDERAL REGULATIONS. RESPONSIBILITY FOR PROPER WASTE DISPOSAL IS WITH
THE OWNER OF THE WASTE.
EPA WASTE CODE: IF DISCARDED (40 CFR 261): NONE.
*** SECTION 14 TRANSPORTATION INFORMATION ***
DOT PROPER SHIPPING NAME: NOT REGULATED BY D.0.T.
DOT HAZARD CLASS: NONE
DOT UN/NA NUMBER: NONE
PACKING GROUP: NONE
*** SECTION 15 REGULATORY INFORMATION ***
U.S. FEDERAL REGULATIONS: AS FOLLOWS -
OSHA: HAZARDOUS BY DEFINITION OF HAZARD COMMUNICATION STANDARD (29 CFR
1910.1200)
SARA SECTION 313:
THIS PRODUCT CONTAINS THE FOLLOWING SUBSTANCES SUBJECT TO THE REPORTING
REQUIREMENTS OF SECTION 313 OF TITLE III OF THE SUPERFUND AMENDMENTS AND
REAUTHORIZATION ACT OF 1986 AND 40 CFR PART 372:
NONE.
TOXIC SUBSTANCES CONTROL ACT:
THIS PRODUCT CONTAINS THE FOLLOWING CHEMICAL SUBSTANCES SUBJECT TO THE REPORTING
REQUIREMENTS OF TSCA 12(B) IF EXPORTED FROM THE UNITED STATES:
NONE.
NEW JERSEY RIGHT-TO-KNOW:
THE FOLLOWING MATERIALS ARE NON-HAZARDOUS, BUT ARE AMONG THE TOP FIVE COMPONENTS
IN THIS PRODUCT:
ACRYLIC POLYMER, WATER, VINYL ACETATE COPOLYMER
PENNSYLVANIA RIGHT-TO-KNOW:
THE FOLLOWING NON-HAZARDOUS INGREDIENTS ARE PRESENT IN THE PRODUCT AT GREATER
THAN 3%:
ACRYLIC POLYMER, WATER, VINYL ACETATE COPOLYMER
CALIFORNIA PROPOSITION 65:
WARNING: THE CHEMCICAL NOTED BELOW AND CONTAINED IN THIS PRODUCT, ARE KNOWN TO
THE STATE OF CALIFORNIA TO CAUSE CANCER, BIRTH DEFECTS OR OTHER REPRODUCTIVE
HARM:
NONE.
INTERNATIONAL REGULATIONS: AS FOLLOWS -
CANADIAN WHMIS: THIS MSDS HAS BEEN PREPARED IN COMPLIANCE WITH CONTROLLED
PRODUCT REGULATIONS EXCEPT FOR USE OF THE 16 HEADINGS.
CANADIAN WHMIS CLASS: NOT REGULATED.
*** SECTION 16 OTHER INFORMATION ***
HMIS RATINGS - HEALTH: 1 FLAMMABILITY: 1 REACTIVITY: 0
VOC LESS WATER, LESS EXEMPT SOLVENTS: 20-30 GM/1(1-2%)
VOC MATERIAL: 15-20 GM/1
The information contained in this MSDS was obtained from current and reliable sources, however, the data is provided without any warrenty, expressed or implied, regarding its correctness or accuracy. Since the conditions or handling, storage and disposal of this product are beyond the control of Imperial Supplies LLC, Imperial will not be responsible for loss, injury, or expense arising out of the products improper use. No warranty, expressed or inferred, regarding the product described in this MSDS shall be created or inferred by any statement in this MSDS. Various government agencies may have specific regulations regarding the transportation, handling, storage, use, or disposal of this product which may not be covered by this MSDS. The user is responsible for full compliance. For more product information by email, click here Imperial Supplies LLC does not provide services and products outside the United States |
Printer-Friendly View
